Advertisement
Using the Pro Extractor Blades
WARNING: NEVER LEAVE THE APPLIANCE UNATTENDED WHILE IN USE.
CAUTION: USE CAUTION WHEN HANDLING THE BLADE ASSEMBLIES AS THE BLADES ARE VERY SHARP.
CAUTION: DO NOT BLEND HOT LIQUIDS.
Allow liquids and foods to cool to room temperature before blending.
This accessory pack includes one set of Pro Extractor Blades
Motor base may vary depending on unit purchased.
IMPORTANT: MAKE SURE THAT THE MOTOR BASE IS
PLUGGED IN FOR USE. NO LIGHTS WILL TURN ON.
IMPORTANT: DO NOT OVERFILL! TO AVOID
SPILLING, DO NOT ADD INGREDIENTS PAST THE
"MAX" LINE.
1
Remove all packaging material and labels from the
Pro Extractor Blades
.
™
2
Wash the Pro Extractor Blades
in warm, soapy
™
water with a soft cloth.
3
™
™
.
CAUTION: Handle the blade assembly with care
when washing as the blades are very sharp.
3
Rinse and dry thoroughly.
4
The Pro Extractor Blades
™
are dishwasher safe. It
is recommended that the blade assembly be placed
on the top rack. Ensure that the blade assembly
is removed from the cup before placing in the
dishwasher.
IMPORTANT: Place the motor base of the main
unit on a clean, dry, level surface such as a
counter or table top.
Fig. 1
Fig. 2
5
Place the blade assembly onto the cup and twist it on
tightly, clockwise, until you have a good seal. (Fig. 1)
6
Turn the cup upside down and place it onto the motor
base, aligning the tabs on the cup with the motor
base. Turn it clockwise, until it "clicks" into place.
(Fig. 2)
7
Follow the operation instructions from the main
instruction manual of the base being used to start.
(Fig. 3)
8
To remove the cup, ensure that the motor has stopped
running. Then turn the cup anticlockwise (Fig. 4) and
pull straight up to remove. (Fig. 5)
Fig. 4
Fig. 3
9
Turn the cup upright and remove the blade assembly
by twisting the blade assembly anticlockwise. Be sure
to store the blade assembly attached to an empty cup
when not in use.
10 Twist the Sip & Seal
lid onto the cup to enjoy your
®
drink on the go. Press flip top cap firmly into the
opening to get the best seal. The flip top cap locks
open when pressed backward.
11 Make sure that the motor base is unplugged when
not in use.
Fig. 5
4
Advertisement
