Advertisement
Quick Links
Advertisement
Related Manuals for DB GROUP HERRAJES Snack
Summary of Contents for DB GROUP HERRAJES Snack
- Page 1 TECHNICAL DRAWINGS MOUNTING INSTRUCTION SNACK P. 1...
- Page 2 THE PACKAGING INCLUDES: A - SLIDES ASSEMBLY (x2) B - 2348 mm SPAR (x2) FOR 411-78.1281.22 - 1748 mm SPAR (X2) FOR 411-78.1282.22 C - 709 mm SPAR (x1) 3.5x14 WOODEN SCREW (x10) BLOCKING PIN (x2) M6x40 SELF THREADING SCREW (x12) 3.5x9.5 SELF THREADING SCREW (x8) P.
- Page 3 CABINET REQUIRED INTERNAL DIMENSIONS WIDTH: 2508 mm (2458 minimum if first slide is inserted in the cabinet side) FOR 411-78.1281.22 WIDTH: 1908 mm (1858 minimum if first slide is inserted in the cabinet side) FOR 411-78.1282.22 DEPTH: min. 800 mm HEIGHT: min.
- Page 4 2458 EXTERNAL SLIDE INSERT A SPACER OVER THE (FIXED TO THE CABINET SIDE) INTERNAL SLIDE INTERNAL SLIDE (FIXED TO THE TOP) P. 4...
- Page 5 TO DISASSEMBLY THE INTERNAL SLIDE, PUSH IT TO THE LEFT TILL IT STOPS (SEE FIG."1"). SLIDES DISMOUNTING USING THE INDICATED HOLE, UNSCREW THE FIXING GRAINS OF THE BALL BEARING SLEDGE MOUNTED ON THE CENTRAL SLIDE (SEE FIG. "2"). TO DO THIS USE A #2.5 ALLEN KEY. AFTER UNSCREWING THE TWO GRAINS, PUSH THE INTERNAL SLIDE TO THE RIGHT AND DISMOUNT IT (AND THE SLEDGE) FROM THE OTHER TWO SLIDES (FIG.
- Page 6 INTERNAL FRAME ASSEMBLY INTERNAL SLIDE DISMOUNTED AS SHOWN ON PAGE 4 INTERNAL SLIDE DISMOUNTED AS SHOWN ON PAGE 4 UPPER SIDE INTERNAL SLIDE DISMOUNTED AS SHOWN ON PAGE 4 BUTTON SIDE (WITH COUNTERSINKED AND BIGGER HOLES) M6x40 (x12) TO ASSEMBLY THE INTERNAL FRAME, USE THE INCLUDED M6x40 SCREWS.
- Page 7 MECHANISM FINAL ASSEMBLY LOOK AT THE DOT RUBBER PART SLEDGE FRAME ASSEMBLED AS SHOWN ON PAGE 5 SLEDGE TO ASSEMBLY THE FRAME ON THE SLIDES, SLIDE INSERT IT FROM THE BACK OF THE SLIDES AS SHOWN AND THEN REPOSITION THE TWO BALL BEARINGS SLEDGES.
- Page 8 ASSEMBLY TO THE CABINET SIDE TO ASSEMBLY THE MECHANISM ON THE CABINET, USE THE "D" WOODEN SCREWS INSERTED IN THE FIVE HOLES IN THE EXTERNAL SLIDES. EXTERNAL SLIDE (x5) FURNITURE CROSS_SECTION 222,5 62,5 P. 8...
- Page 9 TABLE TOP TO FIX THE TABLE TOP, USE THE 8 DIAM. 6 HOLES (TWO IN EACH INTERNAL SLIDE AND FOUR IN EACH SPAR). THESE HOLES ARE INDICATED AS "A" ON THE FIGURE. ON EACH SPAR THERE ARE TWO ADDITIONAL M6 HOLES AT YOUR DISPOSAL FOR FITTNIG PROPER SPACER TO BE INSERTED BETWEEN THE FRAME AND THE TOP.
- Page 10 BLOCKING PINS IF NECESARY, MOUNT THE TWO BLOCKIN PINS (F), ONE FOR EACH SIDE. USE THE 3.5 SCREWS (G) TO FIX THEM THIS PART MUST GO UP WHEN YOU WANT TO MOVE THE TOP. IT SHOULD ENTER IN A HOLE DRILLED IN THE TOP THIS END OF THE PIN GOES DOWN WHEN THE MECHANISM IS OPENED AND MUST ENTER IN A HOLE DRILLED...