Download Print this page

TIP TIPINF001 User Manual

(2) Mode: Long press mode switch hole for 3 seconds to switch the temperature

measurement mode (Sur: surface mode, bod: object mode, Cou: counting mode)

Fig. 11

3.Install and replace battery

（1）Remove three screws

（2）Open the back base and install 18650 Li battery

2.Bracket fixing

1.Nail hook

1.It is the user's responsibility to ensure the electromagnetic compatibility environment of

the device so that the device can work normally.

2.It is recommended to evaluate the electromagnetic environment before using the device.

3.When changing the operating environment, the device must be left to stand for more than

30 minutes.

4.Please measure the forehead to the thermometer.

5.It is not recommended to use it outdoors or under strong light.

6.Keep away from air conditioners, fans, etc.

7.Please use qualified, safety-certified batteries, unqualified batteries or non-rechargeable

batteries used may cause fire or explosion.

8.If it cannot work after install the battery, please insert the charging cable to charge it and

it can be used normally.

TIP TEMPerature Products

340 W Broad Street, Burlington, NJ 08016

1-800-TIP-TEMP (847-8367)

EveryDegreeMatters@tiptemp.com

Fig. 12

Fig. 13

3.Double-sided adhesive sticking

Infrared Thermometer User Guide

sku: TIPINF001

Table of Contents

Do you have a question about the TIPINF001 and is the answer not in the manual?

Page 1 8.If it cannot work after install the battery, please insert the charging cable to charge it and it can be used normally. TIP TEMPerature Products sku: TIPINF001 340 W Broad Street, Burlington, NJ 08016 1-800-TIP-TEMP (847-8367) EveryDegreeMatters@tiptemp.com...
Page 2 1.Introduction 3.Status Description 1. Standby: The red dot in the bottom of the display lights up in turn. (Fig. 1) 2. Insufficient power: The horizontal bar lights up in the middle of the display. (Fig. 2) 3. Normal temperature: Flashing green lights and alarm ‘Di’. (Fig. 3) Fig.