ACU-RITE MILL PWR G2 Software Update

MILLPWR
SOFTWARE
UPDATE
NOTE: HEIDENHAIN Corporation recommends making a backup of the control with the
included USB Recovery Drive (684138-xx) before updating the control software. Please refer to
the manual included with the drive for the backup procedure.
These enhancements/changes were made:
Removed flicker in the DRO and status views
Corrected an issue when saving a program and re-entering the program functions the program
preview image would be old and not update until cursoring to another item and then back.
Corrected an issue with the off-line software in which the on-screen keypad would sometimes
fail to connect to the MILLPWR application software in Windows 8+.
Corrected the following polar/Cartesian entry issues:
1. A coordinate was sometimes shown with the wrong polar/Cartesian setting when a
step dialog was reopened.
2. When a step dialog coordinate defaults to polar (previous step was polar), the
coordinate was not resolved correctly.
3. Use most recent X/Y/R/A fields when resolving coordinate.
Corrected an issue where exploding an engrave line or arc in a program that contained multiple
tools could cause the exploded engrave lines to appear in the wrong positions.
Corrected an issue with the GoTo Line Dialog, in which the Line Count would be one too many
in most cases.
Corrected an issue in which the GeoCalc list view footer did not always update when the list
contents changed.
Corrected an issue where pressing GO at the exact "Instant" the system pauses you could very
rarely get the system to timeout instead of resume
The following compatibility errors with legacy MPT programs have been fixed:
1. The HELIX offset (inside/outside) was not loaded correctly.
G2
August 5, 2015
G2
MILLPWR 2 & 3 Axis
(Version R3SP2)