ARB 4100005 Fitting Instructions Manual

ARB Rooftop Tent & Mounting Brackets
Please disregard instructions supplied with tent
! PLEASE PROVIDE A COPY OF THESE INSTRUCTIONS TO THE CUSTOMER !
IMPORTANT:

Read all instructions and check fitting kit contents before starting

This product can only be fitted to vehicles with a roof load rating of 100 kg or greater

If you are unsure at any point of fitting. Please contact your ARB dealer for advice.

Fitment can be undertaken with one person, however at least two people or a required to lift the tent into
place

Kit 4100005 is only for use on cross bar types Thule Aero, Thule Wing, Thule Professional & Rhino Vortex

Kit 4100006 is only for use on cross bar types Thule Square bar & Rhino Heavy Duty
CARE OF YOUR TENT:
Please refer to the "Owner's Manual" section at the end of this document. This should be given to
the purchaser after fitting
WARRANTY:
Please refer to ARB "Warranty against defects" booklet available from your dealer. A copy of this
booklet should be given to the customer.
SAFETY:
The ARB roof top tent mounting brackets must only be used for ARB tents. Use of these brackets for
use other than intended may lead to product failure and pose a serious safety risk.
Fitment must be followed as per instruction, ensuring all bolts are tightened correctly. Failing to
install correctly may lead to product failure and pose a serious safety risk.
17-06-2014
If you have any queries regarding the installation of this product please contact the distributor from whom it was purchased, or alternatively the ARB office in your state.
Head Office – ARB Corporation Ltd VIC: 42-44 Garden Street, Kilsyth, Victoria, 3137 Tel: (03) 9761 6622 Fax: (03) 9761 6807
WA:(08) 9244 3553 NSW: (02) 9821 3633 ACT: (02) 6280 7475 SA: (08) 8244 5001 QLD: (07) 3872 3872 NT: (08) 8947 2262 TAS: (03) 6331 4190
Installation Time: Approx. 1.5 hours approx.
Page 1 of 14 ARB Copyright 2014 3789276