Installation; Windows Nt - Black Box PC↔422/485 Instructions Manual

PC ↔ 422/485 SERIAL INTERFACE
You MUST set up the operating system BEFORE you physically install
the Card.
3.1 Software Installation
If you are installing an ISA adapter in DOS, OS/2
appropriate directory on one of the Serial Utilities Disks for instructions.
3.1.1 W
INDOWS
Please refer to the /WINDOWS sub-directory on the Serial Utilities Diskette for
help files and current information on the installation of the Card in this operating
environment.
3.1.2
W 95/98 U
INDOWS
For the ISA card, run setup on disk two of the Serial Utilities Diskettes before
installing the card. Make note of the resources that Windows assigns the adapter,
and set the adapter to match those resources. Power down the computer and
install the adapter as described in Section 4.2. If you wish to change any resources
assigned to the adapter, refer to the help file installed in the Black Box folder in
the Start, Programs menu.
3.1.3 W NT
INDOWS
For the ISA card, run setup on disk two of the Serial Utilities Diskettes before
installing the card. After installing the software, refer to the help file that
automatically comes up for installation instructions.
3.2 Hardware Installation
The PC 422/485 Serial Interface can be installed in any of the expansion
↔
slots in any type of personal computer, provided it has an ISA bus:
10

3. Installation

3.1
X
SERS
IMPORTANT
® , or QNX, please refer to the