Powering the BLAST u4/u4m
The information below describes the powering of any GigaSpire BLAST.
To power up the BLAST u4 or u4m
1. Locate the 12 VDC Power Adapter.
2. Attach one end (2-pin barrel connector) to the rear of the BLAST u4/u4m.
3. Plug the other end into any available 110/220 VAC wall outlet.
4. The GigaSpire BLAST begins its start-up sequence (Flashing blue LED).
GigaSpire BLAST u4/u4m Power Connection
Proprietary Information: Not for use or disclosure except by written agreement with Calix.
.
33