Advertisement
Available languages
Available languages
EN
Lighting systems
CLG-S type
M O U N T I N G
I N S T R U C T I O N S
Light unit features:
•
in accordance with the CEI EN60598-1 Standard and suitable for the purpose herein prescribed
1
Remove the lamp and the plastic protection from the pack.
2
Fit the power cable in the base using a rubber cable clamp (we suggest using a cable
with a nominal size of at least 1.5 mm
If necessary, open the knockouts of one of the lateral plastic covers with a sharp
blade, in order to position the power cable behind the light unit.
3
Fasten the light unit to the mounting surface, using the screws provided, in the
corresponding holes.
4
Connect the three conductors of the power cable to the correct terminals (L, ,N),
respecting the polarity.
5
Reassemble the light unit and the plastic protection. Switch the unit on.
Maintenance: the lamp can be replaced if damaged, removing the plastic protection.
Make sure that the lamp used is of a similar type.
A D V I C E
Disconnect the mains supply before carrying out any operation on the light unit.
- Make sure that the mains supply circuit is equipped with suitable protection.
- Product safety is only guaranteed through the correct application of the following instructions, which
must therefore be followed carefully and retained.
In conformity with 2002/96/EC Directive, this product must be disposed of separately from
household refuse or similar, according to the local legislation.
The assembly instructions are an integral part of the product. They must be issued to everyone who
works with the product. We cannot accept any liability for damage associated with failure to observe
these instructions.
W A R R A N T Y
For warranty conditions see "General Sales Conditions".
All specifications, data and drawings are subject to change without notice.
or 14 AWG).
2
1
2
3
4
5
ON
Advertisement
