wsm Kubota U15 Workshop Manual page 16

[Servicing by skilled personnel or KUBOTA dealer]
Servicing
Check/adjust V-belt tension
Check coolant hoses and
clamps
Grease pilot valve linkage
Change engine oil and oil
filter
Replace the fuel filter 4.)
Change return filter for the
hydraulic oil tank 3.)
Replace the drive unit oil
Change hydraulic oil and
suction filter 2.)
Replace the in-line filter
Replace the air filter elements
1
Change running gear and
track roller oil
Check alternator and starter
motor
Check electric cables and
connections
Safety inspection
Replace the coolant and rinse
the cooling system
Replace coolant hoses and
clamps
Change hydraulic hoses
1.) Under dusty conditions the air filter must be cleaned more frequently or replaced.
2.) When using a hydraulic hammer over 20% → every 800 h.
When using a hydraulic hammer over 40% → every 400 h.
When using a hydraulic hammer over 60% → every 300 h.
When using a hydraulic hammer over 80% → every 200 h.
3.) When using a hydraulic hammer up to 50% → every 200 h.
When using a hydraulic hammer over 50% → every 100 h.
4.) Earlier if necessary.
Elapsed hours of operation
550 600 650 700
Please contact your KUBOTA dealer.
Please contact your KUBOTA dealer.
Please contact your KUBOTA dealer.
) .
Please contact your KUBOTA dealer.
Please contact your KUBOTA dealer.
Please contact your KUBOTA dealer.
Please contact your KUBOTA dealer.
Please contact your KUBOTA dealer.
I-S-14
750 800 850 900 950
WSM U15, U15-3 Service
1000 Interval
250 h
250 h
250 h
500 h
500 h
500 h
500 h
1000 h
1000 h
1000 h
2000 h
2000 h
Annually
Annually
every 2
years
250 h
every 6
years