Repairs - Axis Comet 3 Pilot's Manual

Repairs

Small holes in the canopy can be
repaired using adhesive tape (also
named ripstop).
Larger repairs or cell replacement
should only be carried out by the
manufacturer's authorised agent.
Damaged lines should be replaced by
your Axis dealer or any authorised
workshop. When a new line has been
fitted always check its length against its
counterpart on the opposite side of the
wing. After replacing a line always inflate
the glider on flat ground to check that
everything is in order before flying.
After tree or water landings always
examine the glider carefully. If you
suspect the glider may be damaged in
any way contact your nearest
authorised Axis supplier.
After 100 hours of flying or two years,
whichever is sooner, your Comet 3 must
be checked and tested by the
manufacturer's authorised agent.
Axis Paragliders
Metodějova 5, 612 00 Brno-Královo Pole, Czech Republic
+420 601 526 674
info@axispara.cz
Comet 3 should be kept in best possible
conditions to prevent any failures
and/or non-standard flying
modes/reactions to actual air
conditions. It's your responsibility as a
pilot to ensure that your wing is
airworthy at all times.
13