Related Manuals for Equip 650374
Summary of Contents for Equip 650374
- Page 1 45"-50" Triple Screen Ceiling Mount 200x200/300x300 50" 400x200/400x400 650374 50kgx3 600x400 110lbsx3 RATED INSTALLATION MANUAL...
-
Page 2: Required For Installation
Read the entire instruction manual before you start installation and assembly. If you have any questions regarding any of the instructions or warnings, please contact your local distributor for assistance. CAUTION •Use with products heavier than the rated weights indicated may result in instability causing possible injury. - Page 3 Component Checklist ceiling plate (x3) end cap (x3) cable clip (x6) pole (x3) end cap (x3) end cap (x3) M6 (x12) sliding nut (x14) M8x12 (x18) M8x80 (x9) M8x10 (x2) M8 (x9) D8 washer (x2) locking piece (x6) Double Ended Cresent Wrench (x1) 3mm Allen Key (x1) 4mm Allen Key (x1)
- Page 4 1. Assemble the Pole 2. Attach Ceiling Plate to the Concrete Ceiling 60mm 45mm (2.4") (1.8") ø 12mm (ø 1/2") Mark the Drill pilot holes exact location of mounting holes Insert the expansion bolts into the hole as shown. Once inserted, remove the washers and hex nuts. Attach the hex nuts to the expansion bolts corresponding to the keyhole pattern found on the ceiling plate.
- Page 5 WARNING Installers must verify that the supporting surface will safely support the combined weight of the equipment and all attached hardware and components. 3. Extend the Mounting Rail...
- Page 6 4. Attach Collar to the Mounting Rail Note: ・Keep the mounting direction of collars are the same. ・Ensure the gap between the collar halves on both sides are equal. 5. Install the End Cap...
- Page 7 6. Attach Mounting Rail to Pole √ Once the rail has been determined, firmly tighten the bottom rail to the mounting poles as shown prior to mounting the displays.
-
Page 8: Tilt Adjustment
7. Install the Plastic Cover Attach the Cover Remove the Cover Tilt Adjustment - 2 0 ° , - 1 5 ° , - 1 0 ° , - 5 ° , 0 ° 0 ° - 5 ° - 1 0 ° - 1 5 °... - Page 9 9. Attach TV Bracket Position the adapter brackets as close as possible to the center of the display. Top of the display With the arrow pointing up 9a. Attach TV Bracket to Flat Back Screen...
- Page 10 9b. Attach TV Bracket to Irregular Back Screen Note: Choose the appropriate screws, washers and spacers (if necessary) according to the type of screen. Do not overtighten screws.
- Page 11 10. Hang the Screen √ 11. Secure with Padlock Note: Leave at least 1mm gap between screens. Note: Padlock is not included.
-
Page 12: Level Adjustment
12. Level Adjustment 13. Cable Management Maintenance • Check that the bracket is secure and safe to use at regular intervals(at least every three months).
Need help?
Do you have a question about the 650374 and is the answer not in the manual?
Questions and answers