Summary of Contents for SPW VARIPROFILE VP-64
- Page 1 ® Feathering Propeller Manual for the Feathering Propeller VP-64 and VP-76 2- and 3-blade model made by...
- Page 2 Installation on a saildrive » See that the spacer supplied with your saildrive is mounted. » Slightly paint the thread of the propeller hub (1) with the enclosed TIKAL Tef gel to enable a later easy disassembly » Make sure your anode has good contact with the saildrive. »...
-
Page 3: Pitch Adjustment
Installation on a Shaft Pitch Adjustment » mount the hub (1) on the shaft (2). Make sure the prop » apply a small drop of loctite to the thread of the setscrew In general the pitch settings are done in the factory and are Possible reasons for pitch adjusting might be: taper and keyway mate properly with shaft and key and (4) and tighten (20 Nm / 15 Ft.lb.). - Page 4 Pitch adjustment table Operation & Servicing The VARIPROFILE feathers automatically when the shaft rotation is stopped. After engine start-up and shifting into gear the blades will engage in either forward or reverse. THE BEST WAY TO FEATHER THE PROPELLER IN THE SAILPOSITION IS: Prop.-ø...
- Page 5 Removal instructions Torque settings for the prop-nut DO NOT DISMANTLE THE PROPELLER UNIT (5)! Standard – thread Fine – thread M 14 x 2 40 Nm M 14 x 1,5 40 Nm » Remove the blade assembly (5) from the hub (1). »...
- Page 6 Notes Notes...
- Page 7 Feathering Propeller For further informations visit www.variprofile.com 86 517-09 DE-HH GL Rules I, Part 1, Chapter 2, Section 6 made by Westkai 58, 27572 Bremerhaven Telefon +49 (0)471 / 7 70 47 Telefax +49 (0)471 / 7 74 44 info@spw-gmbh.de, www.spw-gmbh.de...
Need help?
Do you have a question about the VARIPROFILE VP-64 and is the answer not in the manual?
Questions and answers