Page 2
FEATURES 1 - Programming Led; 2 - Programming Led; 3 - Selector Key 127/220V ; 4 - Independent opening and closing door buttons (CM: Common (GND) + BTF = Closing Door Button / Common (GND) + BTA = Opening Door Button) ; 5 - Tamper Sensor;...
Page 3
TABLE OF ALERTS On the right side of the buttons, it has a 7-segment display, where it will signal through numbers and letters what state the menu is in. DISPLAY ERROR NOTE : ENCODER ERROR STANDBY (AT REST) The programming buttons are locked, while some TAMPER SENSOR alert is shown.
Page 4
of the “U” motor through “W” and also the limit switch. Then remove and replace the jumper of MAIN MENU the "TAMPER". When the limit switch is found, the letter “c” will appear on the display, which means to To navigate through the options you must enter the main menu. When the display is in standby continue, press and release the “ENTER”...
Page 5
Already in the function, press the "UP" or "DOWN" key to increase or decrease the ramp size (8) (RATE) that the motor will execute, from 15% to 60%, "0" = 15%, "9" = 60% (Increase and decrease of Press the "ENTER" button to access the "RATE" function. 5Hz).
NOTES WARRANTY TERM The GAREN AUTOMAÇÃO S/A manufacturing equipment, located at Rua São Paulo, 760, Vila Araceli, Garça- SP, CNPJ: 13.246.724/0001-61, IE: acquired by Vs., was tested and approved by the Engineering, Quality and Production departments. We guarantee this product against defects in design, manufacture and...
Page 7
Garen Automação S/A BRAZILIAN IND. CNPJ: 13.246.724/0001-61 FEITO NO BRASIL Rua São Paulo, 760 - Vila Araceli Zip Code: 17400-000 - Garça - São Paulo - Brasil HECHO EN BRASIL garen.com.br MADE IN BRAZIL...