Summary of Contents for LocknCharge FUYL Tower 5
- Page 1 QUICK START FUYL Tower 5 Network Kit What’s required? 30cm x1** *Network hub not included. Note: The customer supplied hub requires a minimum of 7 ports. ** Supplied with the FUYL Tower 5.
- Page 2 Disconnect the pre-installed ethernet cable from the internal RJ45 port at the rear of the FUYL Tower only. Place your network hub (not included) inside the top shelf, behind the control door.
- Page 3 i. Route the hub’s power cable through the rear hole to a power outlet. ii. Connect the network hub to the rear internal RJ45 port using the “E5” ethernet cable. i. Remove blanking plate and replace it with the RJ45 port plate. ii.
- Page 4 Reconnect the pre-installed ethernet cable from the control door to the network hub. 30cm Plug the 30cm ethernet cables to the RJ45 port inside each shelf. Network kit setup for the FUYL Tower 5 is complete. www.lockncharge.com (International) www.pclocs.com.au (Australia and New Zealand)