Advertisement
4.3.
slide the head assembly onto the column.
4.4.
Apply a small amount of light lubricant to the column
to ease movement.
4.5.
Attach the operating lever to the head assembly
and the connecting arm. (fig.3.)
4.6.
Keep the Hex key in magnetic clips on side of head assembly.
4.7.
Use the two bolts supplied to secure the vice to the base. (fig.4.)
4.8.
Bolt the base to a work bench (bolts not supplied).
4.9.
the vice has a quick release/adjustment button. Press to release
the thread then slide in and out to quickly adjust jaw opening, release
button to engage screw thread.
4.10.
Position an electric drill with standard 43mm diameter neck into the
head assembly. tighten the locking collar using the hex key.
4.11.
the head assembly has a reducing sleeve provided to use with 38mm
drill necks.
4.12.
setting the depth Gauge
4.12.1.
determine the depth of hole required.
4.12.2.
release the locking bolt.
4.12.3.
lower the drill using the drill stand handle to the required reading
on the depth gauge, lock the depth adjusting rod with the locking bolt.
© Jack sealey limited
Original Language Version
fig.3
fig.6
ds01 | issue 1 22/01/18
fig.4
fig.5
Advertisement
