Advertisement
45° Side-Exiting Multmedia Panel
2.2 What's Included
Your package should include the following items.
If anything is missing or damaged, contact Black Box
Technical Support on 0118 965 6000 or
info@blackbox.co.uk.
• (1) 45° Side-Exiting Multimedia Patch Panel
• (2) Side brackets
• (1) Rear cable bar
• (24) Cable ties
• (4) 10-32 screws
• (4) 12-24 screws
• This user's manual
3. Installation Steps
1. Mount the panel on a 19-inch rack, as shown
in Figure 1.
Figure 1. Mounting the panel on a rack.
0118 965 6000 | www.blackbox.co.uk
JPMT1024-ANG
45° Side-Exiting Multmedia Panel
2. Attach each side bracket to the matching end of the
bar accordiing to the same marking. See Figure 2.
Slide in
mark "L"
Figure 2. Attaching the side bracket.
3. Snap the rear cable bar into the patch panel, as
shown in Figure 3.
Figure 3. Attaching the rear wire manager.
Page 2
0118 965 6000 | www.blackbox.co.uk
JPMT1024-ANG
45° Side-Exiting Multmedia Panel
4. Load the wired keystone jack into the patch panel.
Make sure the locking knob is locked rst before
sliding in the keystone jack or support tting. See
mark "R"
Figure 4.
NOTE: Ports 1–6 and 13–18 share the same orienta -
NOTE: For best connector loading sequences, start
Slide in
Figure 4. Loading the keystone jack or support tting.
5. Make sure the IDC slot of the keystone jack faces
toward the centre of the patch panel, as shown in
Figure 5.
Page 3
JPMT1024-ANG
tion, while ports 7–12 and 19–24 are placed
in opposite positions. Be sure to follow the
directions during installation.
from the sides and install toward the centre.
locking knob
latch
0118 965 6000 | www.blackbox.co.uk
Page 4
Advertisement
