Advertisement
Jason International, Inc.
8328 MacArthur Drive
North Little Rock, AR 72118
www.jasoninternational.com
MADE IN THE U.S.A.
INSTALLATION and OPERATING INSTRUCTIONS
Jason's radiant surface heaters provide soothing comfort directly to the bathtub's surface.
Operation:
Heater On/Off
Heat Settings
To operate the surface heating option simply press the On/Off button to activate the heater.
1st Press: The keypad will display a red light indicated the heater is on at the 'HIGH' heat setting.
2nd Press: The keypad will begin blinking once to indicate the 'MEDIUM' heat setting.
3rd Press: The keypad will begin blinking twice to indicate the 'LOW' heat setting.
4th Press: The Thermo Comfort heating stops and the system powers off.
•
It is recommended to turn the heater on for at least five minutes prior to entering the bath.
•
The Thermo Comfort system is programmed with an automatic timer that will switch off the heater after 30 minutes
of use.
•
If at any time you feel uncomfortable with the temperature of the heating area, simply press the On/Off button until
the red indicator light is off.
Jason International, Inc. • 501.771.4477
"TO BE REMOVED FOR USE BY THE OCCUPANT."
OWNER'S MANUAL
Thermo Comfort Surface Heater
Page 1 of 2
49-2025-001
Date
03/16
Customer Service : 800.255.5766
Copyright © 2016 Jason International.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for JASON Hydrotherapy Thermo Comfort
- Page 1 It is recommended to turn the heater on for at least five minutes prior to entering the bath. • The Thermo Comfort system is programmed with an automatic timer that will switch off the heater after 30 minutes of use.
- Page 2 • Mount the Thermo Comfort control box at least 1-1/2” (4cm) above the surface where the bath will be installed. • The unit must be connected to a power supply circuitprotected by a ground fault circuit interrupter (GFCI).
Need help?
Do you have a question about the Thermo Comfort and is the answer not in the manual?
Questions and answers