Summary of Contents for RTI VXP-82
- Page 1 It’s Under Control It’s Under Control ® ® VXP-82 VXP-82 All-in-one Presentation System 70-210210-13 V1.1...
-
Page 2: Federal Communications Commission Notice
Cet appareil doit accepter toute interférence reçue y compris des interférences qui peuvent provoquer un fonctionnement indésirable. DECLARATION OF CONFORMITY (DOC) The Declaration of Conformity for this product can be found on the RTI website at: www. rticorp.com/declaration Copyright © 2019 Remote Technologies Incorporated All rights reserved. -
Page 3: Safety Suggestions
It’s Under Control ® SAFETY SUGGESTIONS Read Instructions. Read all safety and operating instructions before operating the unit. Retain Instructions. Keep the safety and operating instructions for future reference. Heed Warnings. Adhere to all warnings on the unit and in the operating instructions. Follow Instructions. -
Page 4: Limited Warranty
Remote Technologies Incorporated’s liability for any defective product is limited to repair or replacement of the product, at our option. If any component of your VXP-82 needs service, please contact Remote Technologies Incorporated by telephone or E-mail for return information. Please do not return products to Remote Technologies Incorporated without return authorization. -
Page 5: Table Of Contents
It’s Under Control ® TABLE OF CONTENTS Federal Communications Commission Notice ........2 Safety Suggestions ................3 Limited Warranty ................4 Disclaimer ..................4 Table of Contents ................5 Chapter 1 - Welcome ................ 7 - Important Notes ..............8 - Product Contents .............. - Page 6 VXP-82 All-in-One Presentation System...
-
Page 7: Chapter 1 - Welcome
The VXP-82 8x2 multi-format matrix switch scales content from a wide range of sources, delivering high quality video via HDMI and HDBaseT outputs. Support for de-embedded audio, mic inputs, and mixing capability enables flexible audio output options. With a built-in control processor and compatibility with the entire range of RTI controllers, the VXP-82 also offers complete automation of the installation. -
Page 8: Important Notes
Two (2) RS-232 Adapters One (1) Installation Guide UNPACKING AND INSPECTION After unpacking the VXP-82, save all of the packing materials in case you need to ship the unit. Thoroughly inspect the VXP-82 and packing materials for signs of damage. Report any damage to the carrier immediately. -
Page 9: Chapter 2 - Features And Description
It’s Under Control ® CHAPTER 2 | FEATURES AND DESCRIPTION The VXP-82 provides superior quality and reliability as well as these features: • 8x2 4K All-in-One Scaling Presentation Matrix Switcher. • Support for HDCP 2.2 and HDMI 2.0 • Seamless audio and video switching. -
Page 10: Front Panel
VXP-82 All-in-One Presentation System CHAPTER 2 | FEATURES AND DESCRIPTION VXP-82 FRONT PANEL DESCRIPTION Name Function POWER LED Indicator Turns red when powered on. STATUS LED Indicator When powered on, the status LED is red, then turns yellow, and then goes out. This indicates the status of the built-in processor. -
Page 11: Rear Panel
Connect to a ZM-24 Zigbee transceiver module for two- way communication with RTI handheld controllers. EXPANSION Connect to a CB-8 connecting block to receive IR signals and two-way RS-485 communication from RTI wired controllers. MIC/LINE IN 1-2 PHANTOM POWER/MIC/LINE IN audio selector switch: Selector switch and PHANTOM POWER: MIC input with phantom power. - Page 12 Ground connection for devices connected to +12VDC, SIGNAL IN or HIGH OUT terminals. SIGNAL IN Used to connect to an RTI RM-433 RF receiver or industry standard IR repeater system. Signal voltage can be from 3VDC - 12VDC. HIGH OUT Used to power up to 10 infrared emitters, an IR blaster, or extending IR control over a long distance (1000 ft.
- Page 13 Name Function RS-232 PORTS 1-2 RJ-45 output ports for RS-232 communication using Cat-5 cable. The VXP-82 ships with two RJ-45 (female) to DB-9 (male) adapters. NOTE: RS-232 communication cabling should be limited to 50 feet (16m) depending on baud rate.
-
Page 14: Pinout
Connect to MIC/LINE IN audio device with the included 3-pole terminal block. AUDIO OUT Connect to audio system using the included 5-pole terminal block. Compatible with balanced audio XLR 5pin DIN cables. DB-9 > RJ45 ADAPTOR PINOUT RJ-45 (VXP-82 RS-232 Output) DB-9 Signal Signal Signal... -
Page 15: Chapter 3 - Installation And Operation
When the VXP-T and VXP-R are connected to the VXP-82, either the VXP-T Transmitter or the VXP-82 Host port must to be connected to the Host computer. The VXP-R host is not active and cannot be routed back to VXP-82 or VXP-T. - Page 16 VXP-82 All-in-One Presentation System CHAPTER 3 | INSTALLATION AND OPERATION VXP-82 CONNECTION DIAGRAM Control System Ethernet Switch Wireless MIC Receiver Display Amplifier Ethernet Switch Ethernet Ethernet HDMI OUT Audio In Audio In VXP-82 USB HOST DP IN CAT-x CAT-x CAT-x...
-
Page 17: Web Interface
CHAPTER 3 | INSTALLATION AND OPERATION WEB INTERFACE The Web UI designed for the VXP-82 is available for basic controls and advanced settings for the device. The Web UI can be accessed through an internet browser. Get Access to the Web UI Connect your PC and the LAN port of the switcher to the same local area network. -
Page 18: Audio Control
VXP-82 All-in-One Presentation System CHAPTER 3 | INSTALLATION AND OPERATION AUDIO CONTROL (1) Audio Switch This section manages distribution of audio input to audio output. Click the switch button (white to green) to select the audio input for the output. -
Page 19: Configuration
It’s Under Control ® CHAPTER 3 | INSTALLATION AND OPERATION (2) Audio Volume Adjust the volume of the output audio. Mute: Click to mute/unmute audio output. By default, the volume of output audio is -10dB. (3) Mic Gain Adjust the volume of MIC/LINE IN audio input. Mute: Click to mute/unmute audio output. - Page 20 VXP-82 All-in-One Presentation System CHAPTER 3 | INSTALLATION AND OPERATION (2) EDID This section allows you to configure EDID setting of each input port. Apply: Click to enable the EDID setting. To set up the EDID setting for HDMI IN1: Go to the HDMI IN1 and select the settings from its drop-down menu.
- Page 21 It’s Under Control ® CHAPTER 3 | INSTALLATION AND OPERATION (3) CEC Control • Output: Select Output port. HDMI OUT or HDBT OUT. • Auto CEC Control (ON/OFF): Click to enable or disable the CEC Auto Control. • Delay Time (1~30min): Click the up/down arrow to set the time for the display to power off automatically when no signal is present.
-
Page 22: Settings
VXP-82 All-in-One Presentation System CHAPTER 3 | INSTALLATION AND OPERATION (5) Host USB Bind This section allows USB ports to be configured to bind with inputs (Except for HDBT IN). By default, USB HOST1 is set to bind with HDMI IN1 and USB HOST2 is set to bind with HDMI IN2. - Page 23 To update the Web UI: Click “Browse” for the update bin file. Then click “Upgrade” to proceed. (5) System This section allows you to reboot or reset the VXP-82 to factory defaults. • Reboot: Click to reboot matrix. • Factory Reset: Click to reset matrix to factory default.
- Page 24 VXP-82 All-in-One Presentation System CHAPTER 3 | INSTALLATION AND OPERATION To reset matrix to factory defaults: Click “Factory Reset” and then click “OK” in the pop-up window. Then wait 30 seconds to refresh and re-login the Web UI. (6) Firmware Version...
-
Page 25: Chapter 4 - Specifications
RS-232 Ports Two, Bi-directional RJ45 Connections Ethernet Port One, 10/100Base-T, RJ45 Connection USB 2.0 Ports One, Programming RTI Com Port Zigbee® Communication Port, RJ45 Connection AUDIO CONNECTIONS Signal Input Two mono analog, mic or line level Signal Output Two stereo de-embedded audio output... - Page 26 VXP-82 All-in-One Presentation System CHAPTER 4 | SPECIFICATIONS VIDEO CONNECTIONS Video Input Three HDMI, One Display port , Two VGA, Two HDBaseT (PoH) (RJ45) Video Output One HDMI, One HDBaseT (PoH) (RJ45) Resolution Range 800 x 600 @ 60Hz to 4K x 2K @ 60Hz HDBaseT Transmission •...
-
Page 27: Chapter 5 - Service And Support
Fax (952) 253-3131 info@rticorp.com Service & Support If you are encountering any problems or have a question about your RTI product, please contact RTI Technical Support for assistance (see the Contacting RTI section of this guide for contact details). RTI provides technical support by telephone or e-mail. For the highest quality service, please have the following information ready: •... - Page 28 VXP-82 All-in-One Presentation System It’s Under Control ® Remote Technologies Incorporated 5775 12th Avenue East, Suite 180 Shakopee, MN 55379 Tel: 952-253-3100 Fax: 952-253-3131 www.rticorp.com © 2019 Remote Technologies Inc. All rights reserved.
Need help?
Do you have a question about the VXP-82 and is the answer not in the manual?
Questions and answers