JDE PROFESSIONAL Milk Master Pro User Manual page 21

5- Cleaning 5- Cleaning
5.4 Milk system cleaning with tablet - Excellence Coffee Machines (cont.)
Caution:
To preserve the freshness and good hygiene
of the milk system's hydraulic parts, cleaning
with a tablet must always be performed daily
as requested on the coffee dispenser's display.
The cleaning tablet is required to be able to
complete the automatic cleaning cycle and
cannot be omitted.
Use the following steps to clean the milk system with
a tablet:
1. The coffee dispenser will show "Cleaning or
flushing required" on the display which indicates
that the Milk Master Pro must be cleaned (See
Fig.1).
2. Press the START and ENTER buttons
simultaneously for 3-4 seconds to start the
cleaning (See Fig.2).
3. The coffee dispenser will show "Please prepare
FMU cleaning and press 'Start'" on the display (See
Fig.3).
4. Place a 4L cleaning container under the coffee
dispenser's outlet to catch all cleaning water (See
Fig.4).
5. Open the door and partially remove the milk tank
from the Milk Master Pro (See Fig.5).
6. Pull the milk suction tube out of the tank lid (See
Fig.6).
7. Empty the milk tank (See Fig.7).
8. Rinse the milk tank and lid with warm water (use a
mild cleaning agent to wash the tank, if necessary)
(See Fig.8).
9. After rinsing or washing, dry the tank and lid (See
Fig.9).
10. Insert the milk suction tube into the cleaning
container (See Fig.10).
11. Add one RINZA tablet to the cleaning
container (See Fig.11).
12. Slide the tank back into the fridge, leave the
fridge door open during cleaning to prevent
steam build-up in the cooling area (See Fig.12).
User manual
13. Press ENTER to begin the cleaning (See Fig.13).
14. During cleaning the display will show "Waiting
for FMU cleaning" (See Fig.14). Wait until all
cleaning finishes (See Fig.15). When the
cleaning is finished the coffee dispenser's display
may show "Please remove product pack" (See
Fig.16).
15. Partially remove the milk tank from the Milk
Master Pro. Pull the milk suction tube out of the
cleaning container and insert it back into the milk
tank lid (See Fig.17). Refill the tank with fresh milk
and slide it back into the fridge and close and lock
the door (See Fig.18).
Only if cleaning of machine is overdue as well, the
following steps are applicable:
16. Remove the coffee packs (See Fig.19).
17. Clean the inside of the coffee dispenser's fridge
with a cloth and cleaning brush (See Fig.20).
18. Replace the coffee packs (See Fig.21).
19. Lower the front panel then access the mixing
bowls by pulling the red handle forward (See
Fig.22).
20. Remove the mixing bowls (See Fig.23).
21. Soak the mixing bowls and seals for 15 minutes
in hot water to clean them (See Fig.24).
23. Rinse, dry and reassemble the seal onto the
mixing bowl and reassemble all parts back into
the coffee dispenser then close the front panel
(See Fig.25).
24. Add one RINZA tablet to each mixing bowl (See
Fig.26).
25. Place a 4L cleaning container under the coffee
dispenser's outlets to catch all cleaning water.
Press ENTER to begin the cleaning process (See
Fig.28).
21