Hoftronic MILANO LED User Manual page 3

STANDARD REMOTE CONTROL
The remote control is taught-in as standard from factory setting and does not have to be registered on the transformer. Insert the supplied batteries into the remote
control, which is now ready for use. Below you will find the functions of the remote control.
OPTIONAL WALL DIMMER
The wall dimmer must be paired with the driver, this is not set by default. Below you will find the functions of the wall dimmer and how it is paired to the driver.
OPTIONAL 4 CHANNEL REMOTE
The remote control must be paired with the driver, this is not set by default. Below you will find the functions of the remote control and how it is paired to the driver.
1. SET - Pairing with driver
2. ON - Turn on
3. OFF - Turn off
4. Brightness (+) - Gradually increase brightness
5. Brightness (-) - Gradually decrease brightness
6. Hot Brightness (+) - Brightness in steps 10%, 30%, 70%, 100%
7. Hot Brightness (-) - Brightness in steps 10%, 30%, 70%, 100%
8. Mode - Brightness 100%
9. Night light - Brightness 10%
10. DIY1/DIY2 - Congure DIY modus
11. Delay - Turn off after 30 seconds
Pairing Remote Control
1. Disconnect the power of the driver
2. Press and hold the SET button
3.
Connect power to the driver
4. Release the SET button
5. Press the Mode button 4 times repeatedly
1. ON/OFF - Turn on/off
2. Brightness (+) - Gradually increase brightness
3. Brightness (-) - Gradually decrease brightness
4. Night light - Brightness 10%
5. Delay - Turn o after 30 seconds
Pairing wall dimmer
1. Disconnect the power of the driver
2.
Press and hold the ON/OFF button
3. Connect power to the driver
4. Release the ON/OFF button
5. Press the Night light button 3 times
1. ON - Turn on
2. OFF - Turn off
3. Brightness (+) - Gradually increase brightness
4. Brightness (-) - Gradually decrease brightness
5. Dim - Brightness in steps 10%, 30%, 70%, 100%
6. Night light - Brightness 10%
7. Zone - Selection for the control zone
Pairing Remote Control
1. Disconnect the power of the driver
2. Select the zone with the Zone button
3. Press and hold the DIM button
4. Connect power to the driver
5. Release the DIM button
6. Press the ON button 4 times repeatedly