Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for 3TO podofix
Summary of Contents for 3TO podofix
- Page 1 Instructions for the podofix nail correction brace...
-
Page 3: Table Of Contents
CONTENTS Introduction podofix active glue-on brace How to avoid problems when using Attaching the podofix brace Preparations Gluing the brace on Activating the brace Covering the wire connection Removing the podofix brace Product pointers Safety pointers... -
Page 4: Introduction
The podofix brace is also suitable for cosmetic correction of misshaped nails. As preparatory treatment for application of the 3TO brace or other wire braces a podofix brace can initially be used if the nail fold is still too narrow for insertion of the wire hooks. Duration of treatment... -
Page 5: Podofix Active Glue-On Brace
THE PODOFIX ACTIVE GLUE-ON BRACE The podofix active glue-on brace consists of an elastic plastic pad that sticks to the nail and of an activation wire that tightens the brace after it is glued on. After attaching it the wire lies in the indentation of the plastic pad and can be sealed smooth. -
Page 6: How To Avoid Problems When Using
HOW TO AVOID PROBLEMS WHEN USING In order to avoid mistakes please note the following tips before initially using the brace. Softened nail Please note that the nail may not be softened up before the brace is applied. Foot baths and application of disinfectants or corn softeners to the nail should be avoided prior to application. -
Page 7: Attaching The Podofix Brace
ATTACHING THE PODOFIX BRACE 1. Preparation Polish the nail For gluing on the brace the nail must have as even and smooth a surface as possible. If needed, it can be smoothed or slightly roughened with a cutter or a soft nail file. -
Page 8: Gluing The Brace On
2. Gluing on the brace Apply the glue ! The glue is only applied to the brace and never to the nail. ! If too much glue is applied the brace will not stick to the nail. Wipe off both sides of the brush on the bottle rim. Apply a fine coat of the glue on the whole undersurface of the brace. -
Page 9: Activating The Brace
Then the brace can be pressed down with the tension tool especially in the areas of the edges. ! Wait two minutes before activating so that the glue hardens. 3. Activate the brace Turn the loop Insert the tension tool into the wire loop. Turn the tension tool at least one and at most two complete rotations until the desired tension is attained. -
Page 10: Covering The Wire Connection
4. Cover up the wire connection To seal the podofix brace use the spatula to apply a drop PediGel sealant mould into indentation of the podofix brace. Turn the UV microlamp on by turning the front of the torch clockwise and harden the PediGel by beaming the UV lamp on it for 20 seconds. -
Page 11: Product Pointers
Keep out of the reach of children. General safety pointers The podofix nail correction brace is intended to be used only once. Read these Instructions carefully before using it for the first time and comply with all its suggestions. - Page 12 3TO GmbH Birkenstraße 8 D-82041 Deisenhofen 0049/89/20353444 Fax 0049/89/20353445 info@3to-gmbh.de www.podofix.de © 3TO GmbH 2010...
Need help?
Do you have a question about the podofix and is the answer not in the manual?
Questions and answers