Apex Digital AD-2600 User Manual page 7

Remote Control
PREPARING THE REMOTE CONTROL
To operate the DVD video player, you must first place the batteries in the remote control.
1
Open the cover.
OPERATING WITH THE REMOTE CONTROL
Operating video player with the remote control.
3 0 3 0
!
BATTERIES
INCORRECT USE OF BATTERIES MIGHT CAUSE THEM TO LEAK
• Do not place the batteries in the wrong direction.
• It is dangerous to charge, heat, open, or short-circuit the batteries.
• Do not leave dead batteries or mix new with old batteries in the remote control.
• When not using the remote control for a long duration of time, remove the batteries.When operating range becomes reduced,
replace batteries.
• If battery leakage occurs, wipe the battery liquid from the battery compartment, then replace batteries.
!
REMOTE CONTROL
• The remote control should be aimed directly towards the remote sensor of the DVD video player.
A D - 2 6 0 0
Continued
2
Insert batteries (AAA size).
Make sure to match the + and - on
the batteries to the marks inside the
battery compartment.
The remote control must point at the remote sensor in order for the
player to function correctly.
Distance: Maximum of 7 m from the front of the remote sensor.
Angle: Approximately 30 from each direction.
*Do not place the remote sensor towards any light source such as direct sunlight.
The DVD video player may malfunction.
, .
CORRODE OR EXPLODE
3
Close the cover.
A P E X D I G I T A
7
L