Vision Solid State Logic C10 HD Quick Start Manual

Solid State Logic C10 HD
Requirements
• Large Audio Mixer Interface Software Option
• Serial Interface Cables (DB9 to DB9)
Port Connections
Switcher
REMOTE Port
Communications
(female)
Pinouts
Switcher
2 (Rx-)
3 (Tx+)
7 (Rx+)
8 (Tx-)
Switcher Setup
To Set Up Communications

1. Press HOME Setup
Type.
• Use the Com Port knob to select the REMOTE X port that
you connected the SSL C10 HD to.
• Use the Device knob to select Audio Mixer.
2. Press Select Device.
• Use the Device knob to select RAP.
3. Press Com Type.
• Use the Type knob to select RS-422.
4. Press Com Settings.
• Use the Baud knob to select 115200.
• Use the Parity knob to select ODD.
5. Press Extra Options.
Extra Options
OD Master
TargetMachine

6. Press HOME Confirm.
Audio Mixer

RS422 Port
SSL C10 HD
2 (Tx-)
3 (Rx+)
7 (Tx+)
8 (Rx-)
 
Installation Com Setup
Value
M1 (default)
Generic
To Assign Audio Channels to BNCs
1. Press HOME
2. Use the BNC knob to select the Input BNC that you want to
assign an audio channel to.
3. Use the Audio 1 knob to select an audio channel, or group, that
you want to assign to the selected Input BNC.
4. Use the Audio 2 knob to select another audio channel, or group,
that you want to assign to the selected Input BNC.
5. Press HOME
Refer to your switcher manual for information on creating audio
groups, or setting default audio levels.
Device Setup
Ensure the port on the SSL C10 HD that is connected to the switcher
is configured for RS-422. You must enable REMOTE ON in the SSL
console, via the soft-key.
Compatibility
Audio Mixer
Solid State Logic C10 HD
Synergy 1 SD

Synergy Series SD
Synergy MD/X
Vision MD/X
Vision QMD/X
Vision MultiPanel Support
Automation
OverDrive
Port Expanders
BSS4
Comtrol DeviceMaster
a. You must set Server/Client to Server on the Com
Settings of the Communications Menu 1-2 when
connecting to a Comtrol DeviceMaster.
  
Setup Installation BNC

Confirm.
Switchers
a
4999DR-167 Rev. 1

Audio.
Version
--
--
--
--
--
16.0
--
12.0 or higher

