Advertisement
Quick Links
Tools
Part No
Description
00797-08
Sleeve pin tool
01765-04
Pull up tool
04705-03
19 mm wrench
-
14 mm socket wrench
-
3 mm Allen key
In the table above, tools needed for installation
only. For vehicle specific tools, see the vehicle
service manual.
Fork Kit Adventure for KTM 690 Enduro R
FKA 108
Mounting Instructions
Kit Contents
Description
Cartridge Kit
Sticker Öhlins
Sticker Öhlins
Owner's manual
Notee!
1
Before you install this product, check the kit
contents. If anything is missing, please contact
an Öhlins dealer.
⚠
arninge!
This kit should only be installed by an authorized
Öhlins dealer. The installation procedure
requires proper knowledge and tools.
⚠
arninge!
Before you install this product, read the Öhlins
Owner's manual. This product is an important
part of the vehicle and the vehicle stability.
Notee!
1
Please note that during storage and transport,
especially at high ambient temperature, some
of the oil and grease used for assembly may
leak and stain the packaging. This will not cause
damage to the product, wipe off the excessive
oil or grease with a cloth.
Notee!
1
Please note that there can be small differences
between your product and the images in
these instructions.
Part No
Pcs
FKA108
1
00191-32
2
00191-33
2
07287-01
1
Advertisement
Subscribe to Our Youtube Channel
Summary of Contents for Öhlins FKA 108
- Page 1 Notee! Please note that there can be small differences between your product and the images in these instructions. Fork Kit Adventure for KTM 690 Enduro R FKA 108 Mounting Instructions...
- Page 2 MOUNTING INSTRUCTIONS 1 Remove the original cartridge kit ⚠ arninge! Notee! We strongly recommend to let an Öhlins dealer Before you install this product clean the vehicle. install this product. ⚠ arninge! Remove the front fork from the vehicle, see the If you work with a lifted vehicle, make sure that it vehicle service manual for correct procedure.
- Page 3 MOUNTING INSTRUCTIONS 2.4 Fill oil Öhlins front fork fluid (01309-xx). 2.5 Pump out all air See the Owner’s manual chapter 2.1. 2.6 Set the oil level See the Owner’s manual chapter 2.2. Recommended level see Setup data. 2.7 Install the spring See the Spring recommendation in this folder.
- Page 4 2.13 Install the front fork legs into the triple clamps 2.13 at the recommended Fork leg position according to Setup data. Tighten according to the recommendations in the vehicle service manual. Notee! Measure the fork leg position from the upper triple clamp to the top of the outer tube.
Need help?
Do you have a question about the FKA 108 and is the answer not in the manual?
Questions and answers