Operation - PRODIS EP594 Manual

C. OPERATION
Charge the power bank
This power bank can be charged in 2 ways:
1. by USB – port from your computer or laptop:
•
To (re)-charge the built-in battery using your computer or laptop, take the USB cable and plug the USB end into your computer's USB port. The opposite site of the
cable has to be plugged into the input port of the solar power bank.
•
When the built-in battery is being charged, the red LED will light, when the battery is fully charged, the LED will turn off.
•
It will take about 3 hours to fully charge the battery by USB-port.
2. by bright sun light:
•
To charge the built-in battery by bright sun light you have to expose the solar panel to bright sun light.
•
The time required to fully charge the built-in battery is dependent on the quality of the light available. The stronger the light, the faster the built-in battery will be
charged.
•
Please take off the plastic protection from the adhesive board.
•
In bright sun light it will take about 13 hours to fully charge the built-in battery.
Note: It is necessary to fully charge the built-in battery of the power bank by the USB – port from your computer or laptop before the first usage and every time when you
completely drained the built-in battery.
Charge a digital product with your solar charger
•
It might not always be possible to fully charge a device, since different devices require different power supplies. For the same reason this charger is not suitable for
charging all your digital products.
•
Please check the specified requirements of your digital product first and only try to charge your device if it matches with the technical data of this solar charger.
•
To charge your digital product, please use the USB cable which supplied with the digital product you want to charge. Connect the cable to the product and then
connect the USB end to the USB port of the solar charger.
•
When charging a digital product, the product itself will indicate that it's being charged.
D. WARNINGS
•
Do not use the Power Bank for anything other than its intended use.
•
Keep it away from heat sources, direct sunlight, humidity, water or other liquids.
•
Do not connect input and output conversely.
•
Disconnect it from the USB connector after completion charge.
•
Do not use it with wet hands.
•
Do not subject it to strong impacts and do not throw it.