Advertisement
Available languages
Available languages
Quick Links
1
* Determine the cabinet internal width and depth before starting the design of
drawer.
3
* Drill the slide mounting holes.(Use the Smart Drilling Jig with ruler or Smart
Drilling Jig in order to work of drawer properly.)
5
* Slider hole axises can be drilled by using Smart Drilling Jig.
7
* Drill the Smart lock fixing holes and drawer back holes
by using lock template.
9
*Pull the "C" handle to displace drawer.Use "B" nut to adjust left-right and
"A" nut to adjust up and down.
Full Extension
Manual
2
DIW = Drawer Internal Width
CIW = Cabinet Internal Width
DD = Drawer Depth
NL = Nominal Length
* Install the drawer according to the dimensions above.
4
250
300
350
400
450
500
550
600
* Mounting hole axises were given above according to lenght of slide.
6
* Screw the slider to the cabinet from the holes shown in figure with
chipboard screw Ø3.5x16.
8
* Use angled holes to mount smart lock when wooden
floor width is selected less then 12 mm.
10
* Drawer can be displaced by pulling the "C" handle.
25301740 / 02-15.07.2009
Advertisement
Related Manuals for samet Smart Slide Full Extension
Summary of Contents for samet Smart Slide Full Extension
- Page 1 Full Extension Manual DIW = Drawer Internal Width CIW = Cabinet Internal Width DD = Drawer Depth NL = Nominal Length * Determine the cabinet internal width and depth before starting the design of * Install the drawer according to the dimensions above. drawer.
- Page 2 Tam Açılımlı Ray Kullanım Kılavuzu ÇİG = Çekmece İç Genişliği KİG = Kabin İç Genişliği ÇD = Çekmece Derinliği NB = Nominal Boy * Çekmece imalatına başlamadan önce kabin iç genişliğini ve kabin * Çekmece imalatını yukarıdaki ölçülere dikkat ederek gerçekleştirin. derinliğini ölçünüz.
Need help?
Do you have a question about the Smart Slide Full Extension and is the answer not in the manual?
Questions and answers
looking at online instructions for the Samet slide full there seems to be a slight contradiction ... i have found one source says the internal width of the draw box should be the calculated by taking the width of the cabinet opening minus 45 mm ....where as another source says it is the width of the cabinet opening minus 42 mm .. which is correct please