Hydro systems Ston Series Installation Instructions Manual

Hydro systems Ston Series Installation Instructions Manual

Freestanding models

Advertisement

Quick Links

Safety instructions and important installation instructions ........................................................
Bathtub installation ....................................... .......................................................................
Supplemental installation information for freestanding tubs ..............................................
Installation instructions for tubs without a pedestal ............................................................
User maintenance and cleaning instructions ...........................................................................
Limited warranty ........................................................................................................................
INSTALLER: Please pass these important
instructions along to the homeowner!
C O L L E C T I O N
INSTALLATION INSTRUCTIONS
FOR FREESTANDING MODELS
TABLE OF CONTENTS
Please refer to www.hydrosystem.com for
videos on how to install your bathtub and get
specific dimensions on your model bathtub.
1
page 2
.......... page 3
...... page 5
....... page 6
..... page 7
.... page 8

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Ston Series and is the answer not in the manual?

Questions and answers

Summary of Contents for Hydro systems Ston Series

  • Page 1 C O L L E C T I O N INSTALLATION INSTRUCTIONS FOR FREESTANDING MODELS TABLE OF CONTENTS Safety instructions and important installation instructions ............page 2 Bathtub installation ........................page 3 Supplemental installation information for freestanding tubs ............
  • Page 2 DO NOT INSTALL THE TUB if any of the above is not correct. Contact the dealer where the bathtub was purchased or call Hydro Systems directly at 661-775-0686. You will need to know the bathtub serial number attached to your warranty card and also located on...
  • Page 3 INSTALLATION INSTRUCTIONS BATHTUB INSTALLATION PREPARATION FIGURE 1 Clean, level, and prepare the floor for installation. Place the unit in the exact installed position on the floor and trace the outline of the bath with a pencil or any erasable marking (Figure 1). Templates for Freestanding bathtubs come with the tub.
  • Page 4 INSTALLATION INSTRUCTIONS INSTALL BATHTUB FIGURE 5A Apply generous bead of adhesive or silicone to the bottom of the tub supports (Figure 5A). Then apply a bead of tub and tile caulk or silicone around the edge of the base (Figure 5B). FIGURE 5B FIGURE 6 Carefully set tub into position (Figure 6) and connect...
  • Page 5 INSTALLATION INSTRUCTIONS COMPLETE BATHTUB INSTALLATION FIGURE 8 Fill tub with water to the overflow and then drain the tub while inspecting the waste connections below the floor for leaks. Access from below will be necessary for this step (Figure 8). •...
  • Page 6 Clearance for the drain will be required and the floor near the overflow will need to be completed after the drain is installed. Please see picture below. Hydro Systems recommends using clear 100% silicone sealant. DO NOT use plumber’s putty.
  • Page 7 Please do not use anything else other than what was instructed. Improper use can result in damage to the tub or its finish and may void the warranty. Keep in mind, if you do end up damaging the tub, scratches can usually be removed, buffed or polished out by an Authorized Hydro Systems Service Agent.
  • Page 8 1) Upon inspection, HYDRO SYSTEMS, INC. at its option will repair or replace any defective or malfunctioning part of its system or bathtub. If repairs cannot be made on site, HYDRO SYSTEMS, INC. at its opinion will repair or replace at the factory.

Table of Contents