Advertisement
Getting started
Front grille
1
Leap Motion
®
camera module
2
Desktop stand
3
Sealing position for recessed installation
4
Fan inlet/outlets
5
Rating plate with serial number
6
Power socket
7
USB Type-C port
8
Security bolting point
9
VESA 100 x 100 mount
10
Registering your STRATOS Inspire
1. Go to the Ultrahaptics Developer Site https://developer.ultrahaptics.com
2. Register your STRATOS Inspire using the serial number on the rating
plate (6) and create an account.
Connecting the hardware to your computer
3. Connect the USB Type-C cable to the port (8) on the rear of the STRATOS Inspire
4. Connect 24V DC Power to the power port (7).
1
2
6
8
4
3
7
5
Caution: Use only the power supply included
or a suitably rated Limited Power Source in
accordance with IEC 62368-1:2014.
Electrical hazard: Use of non-Limited Power
10
Sources, or of power supplies that produce
voltages outside the stated specification may
result in permanent damage to the device,
9
and could lead to electrical hazards including
shocks.
USB port
USB Type-C
Power port
Download and install software
5. Install SDK from www.leapmotion.com.
Leap Motion Orion SDK supports only
NOTE:
Microsoft Windows. To use other operating
systems with the Ultrahaptics SDK, install Leap
Motion Desktop SDK V2.
6. Download and install the Ultrahaptics SDK from
developer.ultrahaptics.com. Guidance and design
notes can be found within the SDK documentation. APIs
including C and C# are available for development
7. Other development tools and demos may be available to
you, including:
•
Demo Suite can be downloaded from the
Ultrahaptics developer site to experience mid-air
haptic sensations
•
Sensation Editor
™
can be downloaded from the
Ultrahaptics developer site to run and customise
mid-air haptic sensations
•
Ultrahaptics Core Asset for Unity allows mid-air
haptics to be easily integrated into Unity projects
for deeper, more immersive interactive experiences.
Contact Ultrahaptics for more information.
Power
Advertisement
