Seat Height; Brake System - BMW Urban Hybrid E-Bike Manual

Rear wheel.
Disconnecting the power cable when removing the rear
wheel.
maintenance. To extract the wheel, follow the next sequence:
1. Hold the connector inserted in the frame stopper (c).
2. Disconnect the power cable pulling from the connector coming
from the motor (d).
3. Lose and completely remove the through axle. The wheel can be
removed.
4. To insert the wheel, follow the reversed process, taking care of
aligning correctly the motor axle with both sides of the frame.

9.4 Seat height.

you have established the desired height, re-fasten the seat clamp
lever or screw.
Warning: You should not see the mark for the minimum height
at any time. In order to guarantee that it is safe, you should
insert the seat post well into the seat tube.
b c

10 BRAKE SYSTEM.

The disc brakes (a)
When it is humid, disc brakes work much quicker than rim brakes
and they offer the normal effectiveness in a shorter period of time.
They need little maintenance and do not wear down the rims.
However, when it is humid, they tend to make noise.
New brake pads should be taken to the optimum level for
to apply the brakes is reduced.
If the disc brakes are worn (b), the travel of the brake lever is
extended. That is why you must regularly readjust the brake lever.
If you are not completely sure or have a question, contact your bike
specialist!
Warning: The braking system uses mineral oil. It is necessary
to change it regularly, according to the intervals set forth in the
maintenance calendar.
a b
63
EN