Page 2
Replace the battery cover and screw. It is recommended that good quality batteries are used (such as Energiser or Duracell). If you are not intending to use the it-Control for an extended period (e.g. a number of weeks) it is advisable to remove the ...
Page 3
2. P ress and release the PAIR button on the front of the it- Control. The red light next to it will begin flashing. 3. W ithin 10 seconds press and release the PAIR button on the transmitter. 4. T he light on the it-Control will continue to flash while the devices communicate with each other. 5. O nce the pairing is successful the red light on the it-Control will stay on for 5 seconds.
Operation If you have paired the it-Control with the it-Send or it-Switch, you must ensure the mode on these devices is set to 0. Use the lead supplied to connect the it-Control to your preferred device. This may be an adapted battery toy or a mains control device. The it-Control offers four modes of operation: • D irect - sometimes also called ‘momentary’, this mode means the attached toy is activated while the switch is held down.
• N ot paired with a transmitter - see pairing instructions. • T ransmitter not set to 0 - set mode on transmitter to 0. • N o batteries in it-Control, or batteries are flat - insert or replace batteries. • B atteries in it-Control flat - replace it-Control works erratically batteries. intermittently. • O ut of range - move transmitter ...
Maintenance Your Simply Works device contains no user serviceable parts. If it does not work as expected consult the troubleshooting guide. If there are still problems with the device please contact your supplier. Warranty Your Simply Works device is warranted against defects in manufacture or component failure. The unit is designed for domestic and educational applications.
Need help?
Do you have a question about the it-Control and is the answer not in the manual?
Questions and answers