Installation And Operation; Installation - Bartscher 150151 Instruction Manual

Protective devices
Protective function
That function is designed for assuring that the device may be activated only after
correct placing of the tumbler on the motor block (contact with the sensor) and
after closing both lid clamps.
Overload/overheating protection

5. Installation and operation

5.1 Installation

Positioning
•
Unpack the device and remove all packing material.
CAUTION!
Never remove the rating plate and any warning signs from the device.
•
Place the device on top of an even, stable, and water-resistant surface which
supports the weight of the device and is not heat sensitive. Moreover the surface
should be smooth and dry so the front suction cups may be properly attached.
•
Never place the device on the table edge to avoid tilting or drop.
•
The operating surface must be easily accessible and large enough. In order to
assure comfortable operation and proper air circulation leave at least 15 cm of
space on the sides and back and 50 cm on the front and top from the walls,
cabinets, etc.
•
Never place the device in humid or wet environment.
•
Never place the device on the flammable surfaces.
•
Never place the device in the vicinity of open fire, electric ovens, heating furnaces,
or other heat sources.
That protection is activated automatically
in case of motor overheating due too long
operation or overloading. Wait for the
device to cool down and press RESET
button in the bottom (drawing on the left).
Then the blender may be used again.
- 27 -