Advertisement
Instructions for replacing the rechargeable battery P3120-1B (6 V/10 Ah)
The housing of the battery consists of a base plate and a
top. Both housing shells are held together on four sides
with metal plates with two screws each.
As soon as the rear screws were removed the base plate can be taken off.
The battery must be completely pushed out of the rack.
The only tool that is required to change the rechargeable battery is
To exchange the battery, the base plate has to be removed; it is required
to remove the 4 rear screws at the base plate before it can be removed.
Attention:
The rear screws are very short. We suggest storing them somewhere safely so
that they are not getting lost during exchanging the battery.
Hold the frame of the upper part with both hands and push the battery to
the back with your thumbs. If you press evenly on both sides, this should
be no a problem.
a cross-head screwdriver.
Advertisement
Table of Contents
Summary of Contents for NTL Inno P3120-1B
- Page 1 Instructions for replacing the rechargeable battery P3120-1B (6 V/10 Ah) The only tool that is required to change the rechargeable battery is a cross-head screwdriver. The housing of the battery consists of a base plate and a top. Both housing shells are held together on four sides with metal plates with two screws each.
- Page 2 Remove the cable lugs from both poles of the battery. Slow movements to the back and forth make this relatively easy. The defective battery is replaced by a new one now. Push the cable lugs back onto the poles of the new battery. Pay attention to the polarity! The red pole of the battery must be connected to the red socket! Carefully push the new battery into the case.
Need help?
Do you have a question about the Inno P3120-1B and is the answer not in the manual?
Questions and answers