Assembling The Heater; Installation - Qlima PEF 5018 Operating Manual

ASSEMBLING THE HEATER

INSTALLATION

•
•
•
•
•
•
•
Installation of the heater
*see relevant pictures 1 – 10 in the front page of this manual
Positioning of the heater
*see relevant pictures 11 – 16 in the front page of this manual
Operation of the heater
*see relevant pictures 17– 18 in the front page of this manual
Maintenance- TURN IT OFF AND UNPLUG FIRST
•
•
Heating element replacement
•
4
18
The manufacturer is not responsible for any harm or damage if attention is
not paid to the points described above.
The use of this product and the elements required for that purpose is entirely
at the end user's own risk.
Make sure to mount the appliance only on a level, horizontal, firm and sturdy
underground. In case of doubt have underground checked by an expert.
WARNING - this appliance must be connected to an earthed power socket.
Make sure that the indication of the different switches can be seen from a
distance of >1 mtr
The heating lights can be vulnerable. Make sure to handle the appliance with
care. Avoid vibrations.
Never immerse in water/liquids. Risk of death
WARNING - Minimum clearance distances (from top: 60 cm, from sides: 150
cm) must always be complied with, the distance should be measured from the
ambient objects to the closest point of the heater
Always keep flammable material away from the heater.
The heater is fitted with a supply cable and molded plug, therefore the ter-
minals should not be interfered with. The following points should be consi-
dered when positioning the heater:
Please observe the minimum safe distance between the heater body and any
inflammable surfaces.
Clearance distance from top 60 cm, clearance distance from sides: 150 cm.
This heater contains no moving parts, it needs very little maintenances.
However, when the heater builds up heavy dirt, use a soft cloth to wipe it
off.
WARNING - Before cleaning unplug from the power supply and wait for some
minutes to cool down.
If the heating element breaks or any has malfunction, it should be only
changed by its service agent