Appliance Desk SUPER COMBO 4400N Directions For Use

Advertisement

Available languages

Available languages

SUPER COMBO 4400N

INSTALLATION

Remove 2 Shipping Rods (located on back panel), this also releases a red tag which frees
the power cord.
Connect Hot & Cold Water hoses (included)
Note: Cold water hookup is needed for condensing drying
Plug power cord into a 110V/60Hz outlet
Insert hose into U-connector and insert into standpipe or over sink 24"-40" high
Attach 4" vent hose (not included) on the exhaust outlet if Venting option will be used
Vented/Ventless drying option - Press button for 5 seconds to select option

LAUNDRY PREP

Load the machine to a maximum of 2/3 full
Use High Efficiency (HE) detergent - approximately 1 tablespoon
Use liquid fabric softener - items tumble more freely and dry faster

OPERATION

WASH & Dry: Press Wash + Dry button - Press START
WASH ONLY: Press Wash only button - Press START
DRY ONLY: Press Dry only button - Press START
Note: Heat will not come on during wool cycle

WASHING TIPS

DETERGENT: Use HE Detergent, Equator is recommended
FABRIC SOFTENER: Downey is recommended to reduce wrinkles
DELAY START: Press to delay start time upto 24 hours

DRYING TIPS

Drying is 30% faster if liquid fabric softener is used
In ventless dryer mode, fabrics will be damp to the touch when unloaded, but will air dry quickly
Over-Drying will cause wrinkles
Wrinkle Guard - Drum will tumble every 5 mins after end of Dryer cycle to reduce wrinkles

DIAGNOSTIC MENU

Code
Description
E1
E2
E3
E4
E5
E6
E7
E8
E9
E10
E11
E12
DIRECTIONS FOR USE
Component
Cycle
PreWash+Heavy
Heavy
STANDARD
Quick 20
Baby
Delicate
Wool
Quiet
For Questions or Service:
www.ApplianceDesk.com
1-800-776-3538
(One time setup)
Approximate
Wash
Dry
Times
Times
23
08
55
TUMBLE ONLY
NO HEAT
35

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SUPER COMBO 4400N and is the answer not in the manual?

Questions and answers

Summary of Contents for Appliance Desk SUPER COMBO 4400N

  • Page 1 SUPER COMBO 4400N DIRECTIONS FOR USE INSTALLATION Remove 2 Shipping Rods (located on back panel), this also releases a red tag which frees the power cord. Connect Hot & Cold Water hoses (included) Note: Cold water hookup is needed for condensing drying Plug power cord into a 110V/60Hz outlet Insert hose into U-connector and insert into standpipe or over sink 24”-40”...
  • Page 2 SUPER COMBO 4400N REFERENCIA RÁPIDA INSTRUCCIONES DE USO INSTALACIÓN Retire las 2 varillas de envío (ubicadas en el panel posterior), esto también libera una etiqueta roja que libera el cable de alimentación. Conecte las mangueras de agua caliente y fría (incluidas) Nota: Se necesita una conexión de agua fría para el secado por condensación.

Table of Contents