Sister Bay MFIRE-RND Setup And Care

Congratulations on your new Fire Table! It is fully assembled and has a few accessories than need
to be put together and placed. Please follow this set of guidelines to ensure your Fire Table will be
ready to use for years to come!

Components

A
CONTROL PANEL

Setup Instructions

1- Position the Fire Table roughly where it will be located. Choose a firm, level surface with a minimum of 24" from
any side wall and at least 72" clearance above in a well ventilated area.
We need access to the inside of the fire table. Carefully set the bags of Glass Gems (E) and box with the Glass
Cover (B) to the side. With the help of a partner, lift the Burner Pan (D) up and hold it to one side. The pan will
remain connected to the Control Panel (A) and Regulator, so don't pull too far. We need just enough room to
remove the box with the Wind Guard (C). Take the box out, set it to the side, and replace the Burner Pan.
C
WIND GUARD
(SHIPPED INSIDE)
Setup and Care
Item No: MFIRE - RND
Fire Table Round
(AS SHOWN)
C
(SHIPPED INSIDE UNIT)
TEMPERED GLASS BURNER
B
(SHIPPED ON TOP OF UNIT)
D
BURNER PAN
E
TEMPERED FIRE
GLASS GEMS
Figure 1
Item No: MFIRE - RECT
Fire Table Rectangle
TEMPERED GLASS
WIND GUARD
COVER
D
BURNER PAN