Advertisement
Control of Sleep Mode:
The sleep mode function is activated and deactivated by pressing the „Sleep „button.
On activating the sleep mode function the appliance goes into the lowest air flow mode
(whisper mode)
Further to this all other functions including lights, display etc are deactivated, other than
the ON/OFF button and the „OFF „sleep mode button
The light luminosity of the control indicators for „Power „and „Sleep" are reduced to 50%
By pushing any button, the lights will be reactivated. If there is no further activity within
3 seconds, the appliance reverts to sleep mode. If, however within the 3 seconds a
further any key is pressed the appliance deactivates the sleep mode.
Light Sensor
The appliance is fitted with a modern light sensor.
The Air Purifier, in automatic mode, monitors the light level in the room. If you switch off
the lights in the room, for instance when going to bed, the air purifier automatically
switches to sleep mode. If the lights are switched on again or the sun comes up the Air
Purifier independently switches back into automatic mode.
Control of the Ionisators:
By activating the „Anion-Button" the Ionisator can be turned on or off. If the Ionisator is
activated the corresponding key lights up in white.
Setting the Timer function:
By repeatedly pressing the „Timer-Key", whilst the appliance is operating, you can
set the run-time. Thereby there are run-time choice' available of 2, 4, 8, or 12
hours. The remaining run-time is indicated next to the „Timer Key". By pressing the
„Timer Key" button again the Timer function is terminated, respectively turned off.
Resetting the Filter Replacement indicator.
A) Main Filter: The Air Purifier signals when the air filter of the appliance shall be
checked or replaced. This check/replace interval counts only for when the air
purifier's operational use is considered normal. By usage above this level, such as
in smoking households or households with pets, the filter should be
checked/replaced more frequently.
Further information to this is available in the Chapter „Filter Replacement"
After checking or replacing the filter the filter change indicator needs to be reset.
For this the respective button/key in the control panel needs to be confirmed.
8
Advertisement
