Related Manuals for albutt F470
Summary of Contents for albutt F470
- Page 1 INSTRUCTION MANUAL PARTS CATALOGUE ALBUTT CONTRACTOR BALE CLAMP F470 THIS MUST BE USED IN CONJUNCTION WITH ALBUTT’S GENERAL OPERATOR’S MANUAL www.albutt.com | 01242 620 252 | keith@albutt.co.uk...
- Page 2 CONTENTS Certificate….…………………………………………3 Safety Instructions…..…..……………………4-7 Parts Lists……..………………….………………….8 www.albutt.com | 01242 620 252 | keith@albutt.co.uk...
-
Page 3: Eu Certificate Of Conformity
EC Machinery Directive 2006/42 EC, and the Transposed Harmonised Standards: BS EN 1553 (2000) Alistair Albutt Managing Director www.albutt.com | 01242 620 252 | keith@albutt.co.uk... -
Page 4: Safety Instructions
A SAFE DISTANCE OF AT LEAST 10M MUST BE OBSERVED BY ANYONE WITHIN THE VICINITY OF THE BALE CLAMP. We recommend that genuine Albutt bolt on brackets are used on these attachments. Any weld on brackets which adversely affect the structure of the product and may invalidate warranty. -
Page 5: Hydraulic Safety
CAUTION Hydraulic oil forced out under pressure can break the skin and cause severe injury. In the event of a hydraulic oil leak stop the tractor flow immediately. DO NOT PUT HANDS NEAR A LEAKING PIPE. Linkage Rotator Grapple www.albutt.com | 01242 620 252 | keith@albutt.co.uk... -
Page 6: General Safety And Accident Prevention Regulations
To ensure stability the timber grapple should be stored in a safe position, supported to prevent it being knocked over. If the implement is to be transported on a trailer then it should be securely attached using suitable restraints. www.albutt.com | 01242 620 252 | keith@albutt.co.uk... -
Page 7: Maintenance
Bearing section BKP-UFI clamp Main frame guide shaft Main frame guide shaft locking plate Clamp arm guide shaft Clamping cylinder DW 60-35-550 Adjusting cylinder DW 50-30-330 Guide strip Plastic bushes Electro/hydraulic switching valve www.albutt.com | 01242 620 252 | keith@albutt.co.uk... - Page 8 Bearing section BKP-UFI clamp Main frame guide shaft Main frame guide shaft locking plate Clamp arm guide shaft Clamping cylinder DW 60-35-550 Adjusting cylinder DW 50-30-330 Guide strip Plastic bushes Electro/hydraulic switching valve www.albutt.com | 01242 620 252 | keith@albutt.co.uk...
- Page 9 1.7 Lateral adjustment of F470 The F470 has been fitted with lateral adjustment for the largest possible range while keeping the frame width to a minimum. The adjustment works as follows: The two clamping sections, connected by the chrome-plated shafts of the clamping arms, can move back and forth.
Need help?
Do you have a question about the F470 and is the answer not in the manual?
Questions and answers