Download Print this page

Best Buy Belize Assembly & Installation

Oval pool

Advertisement

Quick Links

A b o v e G r o u n d P o o l A s s e m b l y & I n s t a l l a t i o n
OVAL POOL INSTRUCTIONS
W A R N I N G :
THIS POOL IS NOT DESIGNED
FOR DIVING OR JUMPING.
DANGEROUS INJURY CAN
RESULT-SHALLOW WATER!!!
Your pool is designed for years of pleasurable, safe, family fun. But, when
used incorrectly, a swimming pool can be dangerous. To insure your pool is
used safely you must observe the following safety precautions:
Do not dive!-Do not jump!- No rough play!- No running or pushing!
Do not walk on the top rail. It can be slippery and is not a walkway.
Be sure to install all safety labels provided with your pool according to the
instructions.
Keep a safety rope 1/4" by 50' with a flotation buoy with an outside diameter of 15".
Have accessible in a prominent area by your pool.
Post near all entrances to pool area; a list of telephone numbers of the:
• Nearest available police
• Nearest available fire department
• Nearest available rescue unit
• 911 emergency number if available
Provide fencing or enclosure which is independent of the house as a closure
around the entire pool area. The fencing must be made of durable material, a
minimum of 4' in height from ground level and with closures with self-latching
locks, to make pool inaccessible to toddlers and uninvited guests. Make sure
P O O L A R E A D I A G R A M S :
1118
1
/
2
1530
IMPORTANT NOTICE! READ BEFORE INSTALLATION
ENCLOSED IN FRAME CARTON IS SAFETY ENVELOPE. THE SAFETY STICKERS MUST BE INSTALLED
AS PER FOLLOWING INSTRUCTIONS. FAILURE TO PROPERLY INSTALL WARNING LABELS WILL VOID
WARRANTY. FAILURE TO MOUNT THESE SAFETY LABELS MAY SUBJECT YOU TO SUBSTANTIAL
LIABILITY IN CASE OF INJURY.
SIGN MUST BE PLACED
ON WALL NEXT TO ENTRY
TO POOL
• Nearest ambulance service
• Nearest available hospital
• Nearest available physician
The diagrams below indicate the amount of straps and vertical
supports for each size pool.
1224
1833
THESE WARNINGS ARE NOT
TO BE REMOVED UNDER ANY
CIRCUMSTANCES! IF THEY
BECOME DISCOLORED OR
FALL OFF, PLEASE REQUEST
REPLACEMENTS WHICH WILL
BE SENT AT NO CHARGE.
gate is always closed. Be sure to follow local building code requirements for load
capacity and fencing if using an aftermarket or homebuilt deck.
Check with your local town for any special laws in your locale.
Never drink alcoholic beverages or use any intoxicants which could hinder your
judgment and reflexes.
Never use pool alone. All children must be supervised continuously.
Do not use pool if bottom is not clearly visible: At night, sufficient lighting must
be available. It is the pool owners sole responsibility to provide adequate
lighting for pool bottom, safety signs and walkways, which exceeds minimum
standards of the IES of North America.
Do not climb, stand or sit on any pool structure or the filter system. Components
such as the filtration system, pumps and heater must be positioned so as to
prevent their being used as a means of access to the pool by young children.
Be sure that all toys, chairs and tables or similar objects that a young child could
climb on be at least four feet (4') from pool.
Do not use pool during electrical or rain storms.
See available National Spa and Pool Institute (NSPI), publications for more tips
on pool safety.
1525
S I G N T O B E P L A C E D O N
L I N E R A B O V E W A T E R L I N E
OPPOSITE ENTRY TO POOL
Refer to the diagram that
pertains to your size pool.
(The dotted line around
the pool is the area need-
ed to assemble pool-refer
to box #1 for dimensions.)
1838

Advertisement

loading
Need help?

Need help?

Do you have a question about the Belize and is the answer not in the manual?

Questions and answers

Summary of Contents for Best Buy Belize

  • Page 1 A b o v e G r o u n d P o o l A s s e m b l y & I n s t a l l a t i o n OVAL POOL INSTRUCTIONS IMPORTANT NOTICE! READ BEFORE INSTALLATION ENCLOSED IN FRAME CARTON IS SAFETY ENVELOPE.
  • Page 2 POOL LOCATION Do not locate pool over underground lines, septic tanks, or under electrical lines. It is essential that the area selected for your pool has a level and firm base. Do not assemble your pool on asphalt, tar or oil base surfaces. Avoid areas with sharp objects, or ground treated with weed killer or other chemicals.
  • Page 3: Step 2: Pre-Assembly

    STEP 2: PRE-ASSEMBLY Oval Upright Use your pool-packing list to separate all pool components, becoming familiar with each part. The following sub-assemblies should be done at this time. Take your time, and be careful not to lose any hardware. 1) Attach hold down plate clip to oval upright using #12 screws. 2) Attach U-bracket clip to the bottom of the oval uprights using two "...
  • Page 4 STEP 4: HOLD DOWN PLATE ASSEMBLY Starting at one end of the straight side, install a slotted hold down plate, which will meet the bottom plate at the beginning of the curved section of the pool. Now take a regular (non-slotted) hold down plate and overlap the one that you just placed. Using the holes in the corners, attach hold down plates to hold down plate clips using a #12 screw.
  • Page 5 STEP 6: STRAIGHT SIDE LEVELING Place a 2" x 8" x 16" patio block under each end of the strut, and a 2" x 8" x 16" patio block under the oval upright as shown (use a 2" x 8" x 8" block for this if you have to). The NOTE: STRAP IS entire strap must be flush with the ground, which will require FLUSH WITH GROUND...
  • Page 6 STEP 8: WALL INSTALLATION Before beginning the wall installation, you may remove a bottom rail to cart in sand or sifted soil for the pool cove, as long as your curved sides remain staked in position (make sure you return the bottom rail to its position). In this step, you will use the wall carton as a base to unravel the pool wall.
  • Page 7 STEP 10: PREPARING THE COVE Using neutral alkalinity sifted earth of fine sand without pebbles, build a 2" base over the entire pool area to protect the liner. Make sure that the straps and hold down plates are TOP RAIL covered entirely.
  • Page 8: Step 11: Upright Assembly

    STEP 11: UPRIGHT ASSEMBLY It is easiest to line all of the uprights up next to each other in a line. It helps to lean them against a fence or some other stur- dy object. On most models, the top of the upright can be identified by either an extra hole in the middle, or one on each side (depending on which model pool you have) for the decorator caps.
  • Page 9 STEP 12: LINER PREPARATION After cove and base are in place, tamp and rake the entire pool area. Make sure that no sand is allowed to remain on the wall above the coving. This may cause pinholes in your liner. Before installing the liner, punch out skimmer and skimmer return holes using using a hammer and a screwdriver.
  • Page 10 STEP 14: LINER ADJUSTMENT Once the liner is held securely in place by coping, tem- porarily pull wrinkles in the floor towards the sidewall evenly, leaving the wrinkles at the cove. When the liner is correctly positioned, there must be no air space between the liner and the ground or sidewall.
  • Page 11 STEP 16: TOP PLATE INSTALLATION OVAL TOP PLATE DROPS INSIDE Now is the time to install the square oval top plates. OVAL UPRIGHT & Simply place each one over a different oval upright and IS ATTACHED ON the stabilizer rail, match the holes on the top cap to those SIDES WITH 2-#10 OVAL SCREWS...
  • Page 12 STEP 18: STRAIGHT SIDE TOP COVER INSTALLATION: First, refer to box #16 on the reverse side of these instructions for the curved side top cover installation, follow- ing the diagram that pertains to your pool. If your pool has a 2 pc. resin top cover, refer to the diagrams below for straight side top cover installation.