Summary of Contents for Lodestar LightBox LS2-OB-G3
- Page 1 LODESTAR LightBox LS2-OB-G3 User manual Device revision D2 Document revision D2 (March 2020)
-
Page 2: Table Of Contents
Table of Contents Page SCOPE…………………………………………………………..…..….3 DANGER & WARNING………………………………….….…3 TECHNICAL CHARACTERISTICS…………..………..…..4 INTRODUCTION……………………………………………..……..5 SIM CARD INSTALLATION AND BATTERY PACK CONNECTION………………………………………….…………… 6 INDICATION TEST………………………………….…………….11 INSTALLATION……………………………....……….17 CONFIGURATION…..........….19 SETTINGS…………………………………………….……………..20 RESET………………………………………………….………………21 MAINTENANCE………………………………………………..23 PACKAGING AND REFERENCES…………………...….24 TROUBLESHOOTING………..…………………………………. WARRANTY SERVICE AND NOTIFICATIONS .…..27 DIMENSIONS……………………………………………………… 28... -
Page 3: Scope
SCOPE This user manual provides general informa on about opera on and maintenance of LightBox. This document describes the device version If you need more informa on regarding technical ques ons, please, contact our technical support. DANGER & WARNING BATTERY WARNING For personnel and product safety, WARNING: The device contains please, read the contents of this user... -
Page 4: Technical Characteristics
FCI >50 METERS, REMOTE > 100 METERS COMMUNICATION DISTANCE KOMORSAN SYSTEM INTEGRATION FULL SCADA INTEGRATION VIA KOMORSAN SYSTEM COMMUNICATION PROTOCOL PROPRIETARY CONFIGURATION KOMORSAN WEB-CLIENT SOFTWARE, LODESTAR APP INDICATION FLAG KOMORSAN WEB-CLIENT, MAGNET, BATTERY RESET DISCONNECTING, LODESTAR APP. TEST LODESTAR APP., KOMORSAN WEB-CLIENT SELF DIAGNOSTIC... -
Page 5: Introduction
GSM modem through the cellular network. LightBox is equipped with a built-in Bluetooth standard radio channel (2.4 GHz). LightBox can communicate with Lodestar fault indicators and a remote control via a bidirec onal wireless connec on. -
Page 6: Sim Card Installation And Battery Pack Connection
SIM CARD INSTALLATION AND BATTERY PACK CONNECTION NOTE: LightBox is delivered with a ba ery disconnected. Before installa on, insert a SIM card and connect a ba ery pack. NOTE: SIM card must not request a PIN code; ● It is recommended to use SIM cards of industrial design, intended for use ●... - Page 7 For SIM card installa on and Ba ery pack connec on follow step-by-step instruc ons: Fig.1.1 1. Unscrew the screws-1 and remove cover-2 (Fig.1.1.) FLAG Fig.1.2 2. At the picture the SIM card holder (3) (Fig.1.2.) UM LightBox Revision D2 (March 2020)
- Page 8 For ba ery pack connec on follow step-by-step instruc ons: 1) Unscrew the screws-1 and remove cover-2 (Fig.1.1.) 2) Prepare the ba ery pack (Fig.1.7.) Fig.1.7 3) Put the ba ery pack into grooves C, connector А – А, connector B - B (Fig.1.8).
- Page 9 Fig.1.3 Fig.1.4 3. Open the SIM card holder as 4. Install the SIM card as shown in the Fig.1.3 shown in the Fig.1.4 Fig.1.5 Fig.1.6 5. Close the SIM card holder 6. Install cover-2 and ghten as shown in the Fig.1.5 the screws - 1 Revision D2 (March 2020) UM LightBox...
- Page 10 4) Install ba ery pack against the stop (Fig.1.9). Fig.1.9 Install cover-2 and ghten the screws – 1 (Fig.1.6) NOTE: A er SIM card replacement, it is recommended to reset LightBox. Normal ba ery pack life up 15 years. Ba ery pack life depends on the number of connected sets, interference situa on, quality of GSM- coverage, the number of recorded faults, number of sessions with the server.
-
Page 11: Indication Test
INDICATION TEST Indica on test should be performed before installa on , in order to check the func onality of LightBox. To start click on the icon "LodestarAPP" on the smartphone. Fig.2.1 A er turning on the mobile device and start LodestarAPP the ether is scanned and a list of available Devices is given. - Page 12 The user can list filter by serial number by calling the bu on Fig.2.3 To connect a smartphone to the device select the desired device in the list of th e available devices (see figure 2.2) As a result, a connec on to the mobile device is established, a session of communica on between the smartphone and the Device is established, and a pairing request icon appears in the upper le corner (see figure 2.4).
- Page 13 To install the pairing a er the appearance of the pairing request icon complete the following steps: 1) Swipe down from the top of the screen, then in the p o p - u p window click "Pairing request" link (see figure 2.5); Fig.2.5 2) In the proposed window click "Pair"...
- Page 14 3) Repeat step 1. 4) In the proposed window click "Pair" Fig.2.7 5) As a result, a connec on to the device is made, a communica on session of the smartphone with the Device is established. To check indica on press “Enable indica on”. Fig.2.8 Revision D2 (March 2020) UM LightBox...
- Page 15 5) A er pressing “Enable indica on” in 120 sec. flag turns yellow. Fig.2.9 6) To disable indica on press “Disable indica on” Fig.2.10 UM LightBox Revision D2 (March 2020)
- Page 16 7) A er pressing “Disable indica on” in 120 sec. flag turns black. Fig.2.11 8) The main menu can be accessed by pressing the bu on in the upper le corner (see figure 2.12, 2.13) Fig.2.12 Fig.2.13 UM LightBox Revision D2 (March 2020)
-
Page 17: Installation
NOTE: Communication module Lightbox The package includes Lightbox serial number 1900012 FI-address: INSTALLATION with Lodestar CL4 SET: Do not forget to write down the serial number 1900009 serial number 1900010 serial number 1900011 The Communication module Lightbox is ready for service and meets... - Page 18 LightBox can be installed on any types of poles. To install LightBox on a pole follow step-by-step instruc ons in Figure 3 below . 1. Insert one end of the strap through the band loop and bend it in the opposite direc on from the “ears”.
-
Page 19: Configuration
* For LightBox se ngs, which can be adjusted via a remote control, see table “SETTINGS” on page 20. Lodestar se ngs are stored in LightBox. For Lodestar configura on can be found in Lodestar manual. Revision D2 (March 2020) -
Page 20: Settings
SETTINGS Table of Se ngs NAME VALUE REMOTE THE KOMORSAN WEB- CONTROL CLIENT SOFTWARE from 1h to 99h Reset me of blinker from 1min to 43200min (30 days) from 10min to 43200min (30 days) Communica on period So ware update Event types to registrate reading... -
Page 21: Reset
Put a magnet on a s ck, and from a safe distance hoist a magnet up to the le end of the Lodestar to the s cker “Test reset” and hold it for 5 seconds. Lodestar must enter into self-test mode and During 5 minutes flag turns yellow - flag is “ON”... - Page 22 During 5 minutes flag turns yellow - flag is “ON” . Then flag turns black - flag is “OFF”. To reset LightBox with a remote control see sec on INDICATION TEST on page 11. To reset LightBox by means of the KOMORSAN WEB-client so ware, see the KOMORSAN WEB-client so ware manual.
-
Page 23: Maintenance
MAINTENANCE It is recommended once a year to perform: - visual check; - func onality test with a Remote control; - func onality test via the KOMORSAN WEB-client so ware; Storage me before commissioning is no more than 1 year. Revision D2 (March 2020) UM LightBox... -
Page 24: Packaging And References
Communication module Lightbox LODESTAR LightBox The package includes Lightbox serial number 1900012 FI-address: INSTALLATION with Lodestar CL4 SET: LS2-OB-G3 serial number 1900009 serial number 1900010 serial number 1900011 The Communication module Lightbox is ready for service and meets technical conditions:... -
Page 25: Troubleshooting
TROUBLESHOOTING To determine malfunc ons in the device opera on: examine this manual ● check if the device housing and/or warranty seals have been ● damaged. In case of damage detec on, contact the manufacturer for non-warranty repair. Instruc ons for Troubleshoo ng Malfunc on Troubleshoo ng Method check the ba eries of a remote control;... - Page 26 ● check with a remote control or via the KOMORSAN ● disabled even when the line WEB-client so ware Lodestar op on “Reset voltage is present. condi ons: Line recovery: ON/OFF” is ON; If the cause of the malfunc on is not detected, please, contact technical support service Contacts can be found in product’s passport.
-
Page 27: Warranty Service And Notifications
Lightbox For date of the shipment and date The package includes Lightbox serial number 1900012 FI-address: INSTALLATION with Lodestar CL4 SET: serial number 1900009 serial number 1900010 serial number 1900011 The Communication module Lightbox is ready for service and meets of the product’s installa on see... -
Page 28: Dimensions
DIMENSIONS Revision D2 (March 2020) UM LightBox... - Page 29 FOR NOTES Revision D2 (March 2020) UM LightBox...
- Page 30 Revision D2 (March 2020) UM LightBox...
- Page 32 DESIGNED BY CONTACT DETAILS ANTRAKS R&D&M Co office@a3.energy www.a3.energy +7 499 450 55 07 Support: support@a3.energy...