First Installation - 1Control SOLO EVO Technical Sheet

1Control SOLO EVO - Technical sheet
control units for gates and garages.
SOLO EVO is equipped with an already mounted IP66 cable gland
that must be used to route the power cable. It is necessary to
remove the batteries and puncture the cable gland with a small
screwdriver before inserting the power cable.
Then connect the power supply to the screw terminal block, taking
care to respect the indicated polarity.
Once the power cable has been inserted and connected, secure
it using the small strap supplied and close the device using the 4
screws supplied.
Date and time
SOLO EVO is equipped with an internal clock that is used to check
the users' access time rights. The internal clock manages the
European daylight saving time independently. The date will be set
automatically by the app at the first start.
Data and limitations
SOLO EVO can control up to 4 different radio-controlled
automations.
It can be used by 50 people / smartphones, you can buy more
users from the app.
App
The "1Control" App is free and can be downloaded from the Stores
for iPhone and Android.
It is compatible with the following systems:
- Smartphone iPhone 4S or later with iOS 9 or later
- Smartphone Android with 4.3 system or later and Bluetooth LE 4
"1Control" app is able to manage many 1Control devices at the
same time.

First installation

1. Power the device (see chapter Power supply)
2. Download the "1Control" app from your smartphone's store
3. Connect with the app to the SOLO EVO and set a secret PIN
code
4. Copy the remote control following the guided procedure by the
app
5. Place the SOLO EVO near the automation to be controlled
Copy of a remote control
The copy of a remote control takes place by following the wizard
available on the app.
SOLO EVO is able to automatically recognize the type of remote
control you are copying and to provide the appropriate copy
procedure through the app.
NB: When copying a remote control it is advisable to be near the
relative gate or garage.
The complete list of compatible remote controls is available on the
1Control website or in the Complete Guide.
Shares
Device administrators can share an access stored on SOLO EVO
via the app.
All users who wish to receive a share must register via the app by
entering their phone number. NB: it is not possible to use the same
phone number to register from different smartphones.
The administrator can share an access to a user by indicating his
phone number. It is possible to set time constraints (start and end
date, days of the week, hours of the day) to shares.
To share an access it is not necessary to be near the device, this
operation can also be performed remotely.
Factory reset
You can completely delete all data stored on SOLO EVO by
restoring it to factory conditions. To reset, press and hold the
internal key for more than 10 seconds. Resetting the device can
take up to 2 minutes.
The restoration of the device causes the loss of all the memorized
remote controls and invalidates all the shares created.
After sales service
In case of problems write to support@1control.it or call the number
+39 329 169 7057
Pack contents
1 SOLO EVO device
1 IP66 cable gland (already installed)
1 wall or pole fastening support
2 wall fastening anchors with relative screws
2 pole fastening clamps
2 batteries (already fitted)
4 locking screws
1 power cable 4 meters
Other details
Dimensions: 39x102x134mm
Weight (batteries included): 350g
GTIN/EAN Code: 8056772850154
2/2