Exceptional Maintenance - RIHO Carmen BZ29005 Installation And Operation Manual

6.3 User tips
In case of health problems: Consult your doctor before using the whirlpool system.
=
The maximum recommended duration for using the whirlpool is 10 minutes.
=
The whirlpool system should not be used immediately after a meal.
=
Bath foam (bubble bath), shampoos or soap should only be used after using the whirlpool system. If these media are
=
used prior to operation or when the Whirlpool bath is in operation, a great deal of foam will be generated.
7.0

Exceptional maintenance

WARNING:
Always switch off the power supply before carrying out any maintenance or other work.
ATTENTION:
The whirlpool service department cannot provide a service if there are no inspection hatches or the inspection
hatches are too small. In these cases, the customer has to make the whirlpool system available at his own
expense!
For extraordinary maintenance, please approach the authorised Service Centres. The guarantee will become void
if the product is used improperly by unauthorised personnel, and the manufacturer's liability for the safety of the
product will be cancelled immediately. If any parts fail, only use original and approved spares, otherwise the
guarantee will become void and the liability of the manufacturer for the safety of the product will be cancelled
immediately.
Detecting and resolving problems.
Problem 1.
The whirlpool does not work when the on/off switch is pressed.
Cause 1:
Is the whirlpool connected to power supply?
Is the tub connected correctly?
Is the power supply workingl?
Solution 1:
Check connections, power supply and fuses.
Cause 2:
Is the water level high enough (bath full indication
The electronically controlled whirlpools are equipped with a level switch that only allows the system to operate if the water
level is high enough.
Solution 2:
Top up the water if there is insufficient water.
If sufficient water is available, check whether the water level switch has come loose during transport or installation work.
If the level switch is not working, contact the Riho Service department.
Problem 2.
Not all hydrojets or bottom jets have a powerful flow.
Cause 1:
Some electronically controlled whirlpools have separate control of certain groups of jets that can be switched on and off
when other Hydro jets operate.
Solution 1:
See Chapter 4.1 Basic Functions. Different combinations can be selected successively.
Solution 2:
Switch off the power supply, wait for a minute, then switch it on again, whereby the electronic system will be reset. If the
problem persists contact one of the RIHO service centers.
IW00290.1
)?
-22-