ELRO LT350512P Manual

ELRO LT350512P – LT351012P
TWIN HEAD SPOTLIGHT
1
3
 LED Light  Lamp Cap
 Wall Box  Main Body
 PIR (Motion Sensor)
INTRODUCTION
The ELRO Twin Head LED Spotlight offers you an
economical lighting solution with extremely low energy
consumption.
During darkness, the built-in passive infrared (PIR) sensor
turns on the Spotlight when the PIR sensor detects a
moving heat source in its coverage area.
Two beam adjustable spotlights allow you to provide the
optimum lighting coverage.
Note: Read this entire manual before you start to
install the system.
SAFETY PRECAUTIONS

DO NOT install when it is raining.

Isolate the power supply before installation.

HO5RNF round flexible cable and drip loops must
be used to avoid water ingress damage to the unit.

Ensure that the power supply is protected by a 6A
circuit breaker or suitable fuse.

Ensure minimum distance of 0.5m away from
lighted objects.
CHOOSING A MOUNTING LOCATION



2
4
WIRING INSTRUCTION
5
(1) WARNING isolate the power supply. An internal
(2) Remove the wall box screw at the base of the unit
(3) Use a pin to punch a small hole in the cable
(4) Route the supply cable through the cable grommet.
(5) Strip approximately 6-8mm of inner core insulation
(6) Refit the Spotlight onto the wall box and secure with
Note: If you need to detach the Spotlight from the wall box.
WARNING isolate the power supply. side and one on the
right side of the wall box. (FIGURE 7). Support the fitting
during the process to prevent it from falling.
1
For the best results, mount the Spotlight onto normal
brickwork 2.0m above the ground.
Avoid aiming the PIR sensor at pools, heating vents,
air conditioners or objects that may change
temperature.
Avoid pointing the PIR sensor at trees or shrubs or
where the movement of pets or animals may be
detected.
single pole wall switch is recommended to allow
easy control of the Spotlight.
grommet, enabling the supply cable to enter the wall
box.
A drip loop is required between the wall box and the
wall to avoid water ingress.
from the supply cable.
the two clips. Refit the wall box screw at the base of
the unit (if fitted).
LIVE
NEUTRAL
Cable Fastener
AC POWER