Hunter PILOT 14G User Manual page 2

PILOT 14G
User Manual
Read the User Manual before using your flashlight.
Package content
 Hunter Pilot 14G – LED flashlight with green light
 Charger cup
 230V AC Charger adapter
 12V Charging cable for car
 2st rechargeable batteries (Li-Ion)
 Remote control
 Fastener for gun mounting
 This User Manual
If anything is missing please contact your dealer.
Charging
Connect the charger adapter into the socket on the back
of the charger cup and then connect to a 230V outlet.
When using the car's 12V cigarette lighter socket, first
connect the charging cable to the charging cup and then
to the cars 12V outlet. Without batteries inserted the
charger has two indicator diodes with green light. Place
one or both batteries in the charger. The chargers
indicator lights are red when charging. When the battery
is fully charged, the indicator turns green.
Note carefully
 Place the batteries with correct polarity in the charger.
Compare with labels on batteries and charger.
 The charging process is individual for the two battery
slots.
 The Li-Ion battery can be charged at any energy level.
There is no need to fully discharge the battery before
charging.
 Do not charge for longer time than 24 hours. Always
keep an eye on an active charger.
 Always use the original Hunter PILOT 14G charger to
get the best battery life.
 Only use the charger for Li-Ion 18650 batteries.
 The charger is for indoor use only.
Using the flashlight
Unscrew the back cover and place the battery in the
lamp. Be aware that the battery is oriented correctly. The
positive battery terminal must be pointed towards the
front of the lamp and the negative terminal on the rear
panel. Then screw the back cover in place.
Turn on the lamp by a press on the power switch located
on the back. To turn off with another press.
To use the remote control unscrew the back cover and
replace it with the supplied remote switch. The remote
Power Switch function is instantaneous, i.e. the lamp is lit
during the time you hold the switch down.
Hunter Electronic AB
www.huntercom.se
Use the supplied bracket to mount the light on your rifle.
The holder can be placed on the telescopic sight or
barrel. The remote switch is to be attached at a
comfortable position on your gun with the supplied
Velcro sticker.
If you do not use the lamp for a long period, remove the
battery. Recharge the batteries every 6 months.
Clean with a damp cloth for it to last longer. Do not use
harsh chemicals or solvents and do not immerse in water.
Troubleshooting
If the lamp does not light up or is unstable: Make sure the
screw inside the back piece does not sit loose. There are
two small indentations in the screw where a pliers with
sharp tips fit. Tighten the screw by turning clockwise.
Warranty
The warranty period is 24 months, unless otherwise
indicated, from the date the product was purchased from
the dealer. Warranty validity must be supported by an
invoice or sales receipt on which / what purchase date
shall be shown together with a problem description.
Rechargeable batteries are classified as consumables and
a 3-month function warranty is given.
If errors are discovered during the warranty period,
contact your dealer.
Warranty does not cover defects caused by negligence or
improper handling of the product.
The warranty does not cover failure due to accident,
abnormal usage, neglected maintenance, improper
maintenance, improper voltage or current type, product
modifications, moisture damage, tamper with or
uncertified repairs.
Missing receipt or description of the defect, the product
is not under warranty.
Technical specification
LED type Cree® XLamp® XP-E R2 (Green)
Light Green
Lumen 250LM
Lens Hardened glass
Reflector Polished aluminium
Material T6061 aluminium
Power 1st Li-Ion battery, 18650
Dimensions 155 x 45 mm (height x diameter)
Weight 215 g (including battery)
Environment Shock and water protected
Designed and developed in Sweden
by Hunter Electronic AB.
Batch: ______