Warranty Statement; Unpacking; Charging Procedure - BlowHard High Flow Jet Series Operation Manual

3

WARRANTY STATEMENT

Please go to www.blowhardfans.com/register and fill out the Warranty Registration form and
submit it to activate your warranty. The High Flow Jet Series PPV fans come with a 2-year
warranty covering all parts from the date of purchase under normal operating conditions.
Any intentional misuse or abuse to the unit, accidental damages and anything outside "normal
wear and tear" to the unit will is not covered under this general warranty policy.
UNPACKING PROCEDURES
Unpack and remove the fan from the cardboard boxes.
If possible, keep the box and molded package braces. If the fan needs to be returned for any
reason, these items will help prevent damage during transit.
Visually check to ensure nothing is loose or broken during shipping. Lay the fan flat on the ground.
Locate the yellow brake lever and compress to lift the shroud part of the fan upright and all the
way over 180 degrees. Take note of the power console and AC cord/plug. Turn the unit on to
verify it is functioning. If anything appears to be damaged, notify us immediately.
CHARGING PROCEDURES
Keep the unit plugged into the truck or wall socket when not in use. This will ensure the
fan is always charged. Remember, there is no charge memory as in NiCad batteries, so
simply plug it in after each use regardless of existing battery capacity.
STEP 1: Make sure the Power Knob is turned to the left and clicked OFF. If the red "BH" LED is
on, the fan is not switched completely off and the fan will not be charging.
STEP 2: Plug in the AC Power cord to an approved 120V-AC extension cord. The green
battery LED will start Blinking Slow GREEN during pre-charge, and then switch to either Fast
GREEN during fast charge, or Slow GREEN during trickle charge, or two green blinks followed
by a longer pause indicating automatic battery maintenance is occuring. When the battery is
fully charged and maintenance complete, the green battery LED will be solid green.
Charge Time: Expected charge times are 0% - 90% capacity during fast charge (fast blink)
completed in 1 - 2 hours, depending on fan. Slow charge (Slow blink) can take 1 hour longer to
complete 90% - 100% capacity. Battery maintenance can take a long time, depending upon if
cell balancing needs to occur. The battery LED will blink green twice followed by a pause,
repeated. Leave the fan plugged in as often as possible to take advantage of the automated
cell maintenance. Operating the fan at any point during this process will not damage the fan or
battery.
High Flow Jet Series Operations Manual v2.1