Fluke Y1586 Instruction Sheet

Introduction
This sheet explains how to use the rack-mount kit (the
Kit) to mount the 1586A Series Data Acquisition
System (the Product) into a standard 19-inch rack
panel.
Warning
To prevent possible injury, do not restrict
access to the Product power cord, which is
the mains disconnecting device. If access to
the power cord is inhibited by rack mounting,
a properly rated accessible proximate mains
disconnecting switch must be provided as
part of the installation.
1
4465021 April 2014
PN
©2014 Fluke Corporation. All rights reserved.
Preparation
Before the Kit is installed, remove the handle, bezels,
and two screws from the Product, see Figure 1:
1. Place the Product on a flat surface and rotate the
Product handle to the vertical position.
2. Pull one side of the handle outward, away from
the Product until free. Pull the other side of the
handle out, away from the Product.
3. Pry and pull the bezels from the Product.
4. Remove the rear-side screws (2) from the
Product.
2
3
Front Bezel
Figure 1. Preparation
Y1586
Rack-Mount Kit
Instruction Sheet
3 Rear Bezel
4
4
#8-32 SCREW
hum101.eps
1