FONESTAR TOUR-1T Quick Start Manual

TOUR-1T, TOUR-1R
EN
WIRELESS TOUR GUIDE SYSTEM AND POINT TO MULTIPOINT
TRANSMISSION
CONTROLS AND FUNCTIONS
1.- TOUR-1R receiver earphone output. Use the earphone provided for the receiver.
TOUR-1T transmitter mic./line input. Use the microphone provided for the transmitter.
If required use the transmitter input as a line level input, connect the audio source using a cable with a 3.5 mm stereo
plug. The transmission is mono (channel L). To adjust the input level to line level, press and hold the "-" button for
approximately 5 seconds. For more information, see Instructions for use.
2.- Information display.
3.- On/off button. Press and hold this button for approximately 2 seconds to switch the transmitter and/or the receiver
on/off.
Note: the receiver will switch off automatically if no signal is detected for 20 minutes.
The TOUR-1T transmitter also incorporates the MUTE function in this button, which deactivates the audio. Press the
button again during transmission to activate/deactivate the audio in the receivers.
4.- Volume control and channel selection. See Instructions for use for more information.
5.- Aerial (only available in the model TOUR-1T).
6.- Internal battery recharging input, micro USB B connector. Recharge the transmitter and/or the receiver using a
suitable cable or by making use of the optional charging case.
Note: the transmitter and the receiver will switch off during the battery charging process.
INSTRUCTIONS FOR USE
TRANSMISSION CHANNEL SELECTION
To change the transmission channel (both in the transmitter and in the receiver)), press and hold at the same time the
buttons "+" and "-" for approximately 2 seconds. At that moment, the channel indicator (CH) in the display will start to
flash indicating that the transmission channel can be modified.
Then press the buttons "+/-" to select the required channel. Wait 5 seconds and the channel will set automatically. The
channel indicator in the display (CH) will stop flashing and the lock indicator will light up again.
Make sure that the transmitter and the receiver operate in the same channel.
TRANSMITTER INPUT LEVEL ADJUSTMENT
The TOUR-1T transmitter automatically adjusts the input level depending on the input connected (mic. or line). If the input
level doesn't adjust automatically, it can be done in the following way:
If connecting a line level input, press and hold the "-" button for 5 seconds until the loudspeaker symbol in the information
display starts to flash. The volume level in the display is set at 1.
If connecting a mic. level input, press and hold the "+" button for 5 seconds until the loudspeaker symbol in the information
display remains permanently lit. The volume level in the display is set at 4.