Table of Contents 3 General Information 4 Package Contents 5 About the ZEISS UVClean 6 Functionality 8 Safety and Operation 8 Cleaning and Recycling 9 Technical Information...
• Is NOT intended for the disinfection of opthalmic lenses Once the ZEISS UVClean is plugged in and turned on, frames in a hospital or other medical setting. can be loaded onto the interior rails with lenses facing up and temples pointing down.
Getting Started Figure 1 Unboxing the ZEISS UVClean Carefully remove the ZEISS UVClean from the box and place on a secure surface. (Figure 1) Locate and remove power cord, box with UVC bulbs, Bulb End Caps, and gloves from the packaging. Retain all packaging materials for future use.
UVC bulbs to illuminate • Solid Red – Bulbs end-of-life indication. The ZEISS UVClean onto all parts of the frames. Continue loading frames to ½” of will be unable to perform a cycle until new bulbs are the rail ends.
Page 7
Step 1 – Reset Device Customer Service at 1-800-201-4143. Turn off power switch on the back of the ZEISS UVClean and wait 15 seconds. Turn the device back on. Close lid and press CAUTION: Only use approved ZEISS UVC replacement the Start button on top of the lid to begin a disinfection cycle.
To prevent dust buildup within the chamber, always keep Redundant safety features are implemented into the ZEISS the ZIESS UVClean lid closed when not in use. Never spray UVClean to prevent accidental UVC exposure, however, it is or pour liquid cleaners inside the device.
DO NOT OPERATE WITH LID OPEN • Power cord: NEMA 5-15 to IEC 320-C13 for use with 120-volt electrical outlets • UVClean electrical power input: 120 VAC, 50/60 Hz, 330 W • Listed by NRTL MET (Canada, USA) :250V, 10A Carl Zeiss Vision Inc.
Need help?
Do you have a question about the UVClean and is the answer not in the manual?
Questions and answers