Adroit Remote for Board V3 Quick Start Manual

Adroit Board V3
Thank you for purchasing Adroit Board V3! Any improper use may cause malfunction and damage to devices, so
please make sure to read through this manual before use and strictly abide by the prescribed operating procedures. We are not liable
for any liability arising from the use of this product, including but not limited to the compensation for incidental or indirect loss. We
also do not bear any responsibility for unauthorized modification of the product. We have the right to change the product design,
appearance, performance and use requirements without notice.

1:Product Specification

Model Remote for Adroit Board V3
3.7V/400MAH
Battery voltage/capacity
Micro USB
Charging interface
Charging time
Communication mode
40m（Open area）
Distance of remote control
Weight
ESC-Skateboard-ADV3
Applicable ESC
1H
2.4G
--
2: I nteractive mode ​

3. Function and operating instructions

Power on

Press "button A" on remote control for 1 second to power on. The remote control will vibrate shortly and enter into connection
mode. OLED screen displays main interface or unconnected hint according to connection state. Then press the power button of
skateboard for 0.2 second to enter into connection mode.
Note: The normal state after connection is that OLED screen displays main interface and indicator light of skateboard is
constantly on.
2) ​ P ower off
Manual off​ : Press "button A" for 2 seconds to power off (The skateboard cannot be powered off under speeding). The remote
control vibrates shortly, press power button for 1 second to power off.
Note: If the skateboard is powered off but the remote control is not powered off and in the state of connection, the screen of
remote control displays not connected, and the remote control vibrates shortly to remind. If the remote control powers off in
the state of connection, the skateboard will start to brake and power off after 5 minnutes of standstill.
Automatical off​ : The romote control and skateboard will power off automatically if not being operated within 5 minutes, if the
skateboard is at rest.
3) ​ C onnect and match(Have been matched well after leaving factory)
​ B oth of remote control and skateboard are powered off, first press button A for 5 seconds, the indicator light is red and flashes
quickly, reminding enter into matching state, press "button A" for 5 seconds again, the screen displays matching and enter into
matching mode. The remote control displays matching successfully, with two short vibration and once long vibration means
completing matching. After that, the red indicator light of skateboard is constantly on and can be used. After matching remote
control, need to select speed, mileage unit and motor diameter, detailed operation method. Button B to switch option. Button A
to confirm. The remote control will enter into main function interface after the second motor diameter chosen.
4) ​ B attery indicator
Battery indicator of remote of control: ​ T here are 5 grid power. After power on, if the battery of remote of control is less than
10%(It can be used for 30 minutes at most), the screen of remote control indicates that the power is less than 10%, with a
double long vibration. When the battery is only 5%(It can be used for 15 minutes). The remote control reminds the battery is
less than 5% again, with a double long vibration. When the battery is lower than safe voltage(3.4V) and connected with
skateboard, if the skateboard stops, the remote control vibrates once and powers off automatically.
Battery indicator of skateboard: There are 5 grid power. When the battery of skateboard is lower than 25%, the screen of
remote control indicates the battery is lower than 25%, with a double long vibration. When the battery of skateboard is lower
than 10%, the remote control will indicates the battery is lower than 10%, with a double long vibration. When the voltage is
lower than safe voltage, close power output, brake immediately at this time.