NOMA 052-9458-4 Instruction Manual

LED Portable Luminaire
Model no. 052-9458-4 | Contact us: 1.866.827.4985
IMPORTANT SAFETY INSTRUCTIONS. SAVE THIS INSTRUCTION SHEET
LED Portable Luminaire
Model: 052-9458-4
Rated: 120V-60Hz 28W
5000K 3000Lumen
X1
X2
LED Portable Luminaire
Chain link
READ ALL THE INSTRUCTIONS AND SAVE THIS INSTRUCTION SHEET.
FAILURE TO READ THE INSTRUCTIONS MAY CAUSE RISK OF FIRE OR PERSONAL
INJURY.
CAUTION:
To reduce the risk of fire, electric shock or injury:
Turn o the switch and circuit breaker before installing this LED lamp.
Suitable for dry locations.
Not for use with dimmers.
Install directly beneath a ceiling-mounted receptacle.
Use only insulated staples or plastic ties to secure the cord.
Not intended for recessed installation or on ceiling.
Do not install directly over a heat source (stove, etc.).
Use safety precautions. Safety glasses and gloves are recommended.
Do not install on a radiant-heat ceiling.
Injury to people and damage to the lamp and/or mounting surface may result if the lamp is pulled from
the surface. To reduce the likelihood of such injury or damage, mount only on a mechanically sound
surface.
Do not alter the plug or power supply cord in any way or try to install this product using any method
other than the method shown on this sheet.

IMPORTANT SAFETY INSTRUCTIONS

This portable luminaire has a polarized plug (one blade is wider than the other) as a feature to reduce
the risk of electric shock. This plug will fit in a polarized outlet only one way. If the plug does not fit fully
in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Never use with an
extension cord unless plug can be fully inserted. Do not alter the plug.
1. This fixture complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
2. To install onto a plaster board surface, plaster board must be at least 3/8" thick.
Instruction Manual
For indoor use
Retain packaging for storage purposes
X2 X2
Screw eye hook
Plastic anchor
LED Portable Luminaire
Model no. 052-9458-4 | Contact us: 1.866.827.4985
1. Mounting surface must be capable of
supporting the fixture. If the surface is
made of plaster board, we recommend
that you use minimum #8 screw eye
hooks with plastic anchors (included) or
expansion bolts (not included). If installed
onto a plaster board surface, we recommend
a minimum 3/8" thickness.
2
42.9" apart
3. Install one "S" hook into each end of the chain,
then crimp the "S" hook end that is attached to
the chain with pliers. (Leave one side open from
the "S" hook) Repeat step for the second chain
provided.
4
5. Install the LED lamp with chains, one end at
a time, onto each screw eye hook. Once installed,
crimp each of the "S" hook ends with pliers.
6
This Noma product carries a 5-year warranty against defects in workmanship and materials.
Noma Canada agrees to replace a defective product, within the stated warranty period, when
returned to the place of purchase with proof of purchase. This product is not guaranteed against
wear or breakage due to misuse and/or abuse.
MADE IN CHINA
Imported by Noma Canada
Toronto, Canada M4S 2B8
Instruction Manual
Retain packaging for storage purposes
1
2. Install the 2 plastic anchors 42.9" apart,
then screw the eye hook into each anchor.
3
4. Install the "S" hook from one end of the chain
into the end cap of the LED lamp, then crimp
the hook end with pliers. Repeat same step
on the opposite side
5
6. Plug the power supply cord into the electrical outlet.
For indoor use
Min.3/8" thick