Nova 052-9457-2 Instruction Manual

LED Portable Luminaire
Model no. 052-9457-2 | Contact us: 1.866.827.4985
IMPORTANT SAFETY INSTRUCTIONS. SAVE THIS INSTRUCTION SHEET
LED Portable Luminaire
Model: 052-9457-2
Rated: 120V-60Hz 22W
5000K 2100Lumen
X1
LED Portable Luminaire
READ ALL THE INSTRUCTIONS AND SAVE THIS INSTRUCTION SHEET.
NOT READING THE INSTRUCTIONS MAY CAUSE RISK OF FIRE OR
PERSONAL INJURY.

CAUTION:

To reduce the risk of fire, electric shock or injury :
Turn o the switch and circuit breaker before installing this LED lamp.
Suitable for dry locations.
Not for use with dimmers.
Use only insulated staples or plastic ties to secure the cord.
Not intended for recessed installation or on ceiling.
Do not install directly over a heat source (stove, etc.).
Use safety precautions. Safety glasses and gloves are recommended.
Do not install on a radiant-heat ceiling.
Injury to people and damage to the lamp and/or mounting surface may result if the lamp is
pulled from the surface. To reduce the likelihood of such injury or damage, mount only on a
mechanically sound surface.
Do not alter the plug or power supply cord in any way or try to install this product using any
method other than shown on this sheet.
1. This fixture complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
2. To install onto a plaster board surface, plaster board must be at least 3/8" thick.
Instruction Manual
For indoor use
Retain packaging for storage purposes
X2 X2 X2
Plastic anchor Screw Clip
X1 X1
Plastic plug Terminal
LED Portable Luminaire
Model no. 052-9457-2 | Contact us: 1.866.827.4985
1. Mounting surface must be capable
of supporting the fixture. If the surface
is made of plaster board, we recommend
that you use minimum #8 screw eye
hooks with plastic anchors (included)
or expansion bolts (not included).
If installed onto a plaster board surface,
we recommend a minimum 3/8" thickness.
2
1
2 "
35
3. Install the LED portable fixture to
the clips so as to fix it.
4
5. Plug the power supply cord into the electrical outlet.
IMPORTANT SAFETY INSTRUCTIONS SAVE THIS INSTRUCTION SHEET
Connect to power outlet
This Noma product carries a 5-year warranty against defects in workmanship and materials.
Noma Canada agrees to replace a defective product, within the stated warranty period, when
returned to the place of purchase with proof of purchase. This product is not guaranteed against
wear or breakage due to misuse and/or abuse.
MADE IN CHINA
Imported by Noma Canada
Toronto, Canada M4S 2B8
Instruction Manual
Retain packaging for storage purposes
Min. 3/8" thick
1
2. Ensure the 2 plastic anchors are at 35 1/2" inches,
then place the clips and the screws in right position.
3
4. Check and ensure that the LED portable
fixture is securely mounted to the surface.
5
Connect to additional light
Link up to 12 lights together
For indoor use